Recent content by ALB1

Thank bob6600 Job only needed the clip as one of the legs was completely gone Happy days no I have no fumes entering the cabin

Hi all Finally the weather is getting better and I am going to tackle this clamp Can someone advise me on the procedure as I don’t want to get caught out My biggest concern is getting the o ring out Is there enough movement to open the gaps between the two parts ? Thanks

Thanks a lot for your help bob

Her you go WDC1631132A509452 Thanks

Thanks bob6600 I will look at it tomorrow and assess what's needed Is there enough movement to get the gasket out without removing any mounting bolts? Also any idea on the part number for the gasket Thanks again

I had the RAC out for a breakdown (it was a fuel line O ring) And the guy said that the clip was broken Can you use them again? Thanks for the quick response

Could be the join on the turbo to cat Looks ok when warm but can leak on start up

Hope someone can help me I am going to change the clamp from the turbo to the cat and was hoping for some helpful advice The clamp looks like it just pushes on Klarius 430639 Also should I replace the o ring seal Thanks

Personally I wouldn't bother with diamond cut as they oxidise after about 6months also springs are a nightmare to change I think you need a special spring compressor

Hello All, Looking for some adviseplease I have a very sorry looking transmition oil cooler and i am going to change it out. firstly can i just unclip the hoses and swap them over and then add some teansmition fluid to replace the amount thats going to spill onto my driveway? also because the...

Hello All, This is about what the Specialist Bosh injector Garage has done me for! took the ML270 2004 with 120k to the what i thought was a Specialist in Aberdeen to get a quote for my Black Death injector they looked at it and advised 1-2 hours as they had seen worse and it didnt look that...

Sorry panic over It's a crap connection on the Earth terminal Managed to get it going so I could get back to work :-) See what it's like on the way home [emoji848] Thanks for the quick response

Help I just got home for lunch everything was fine 40 mins later unlocked the car ok turned ignition on and everything went blank no power enywhere Suggestions please The battery is good

Thanks All Ordered the o rings and they just came in Now I am confused as the o rings came in two sizes the smaller ones are tiny do these go into the pump itself if so how can you do this in situ? Also looking at the pump I see what looks like white flat rubber washers on the left hand side...

Thanks I will try the Orings hopefully the clips will stay intact As for asking MB Aberdeen to help out unless you are buying a 50k plus motor they won't help