Search results

  1. 0ptic

    lock up torque converter

    Well, It's difficult to be sure now but, before I changed my bad habit and followed the above procedure, there was a hard thump about a second after the first to second gear shift at lowish throttle pull offs.
  2. 0ptic

    lock up torque converter

    Hi gazC32 I'm probably going to get laughed off the forum for this post but, here goes. I had the harsh lock up on my C32 and changed most of the bits you did. I also replaced the solenoid as Billy recommends. It was a lot better for a while, but as seems to be the case with this fault...
  3. 0ptic

    Command - not working via streeing wheel buttons

    That sounds like me Alfie :-) Thanks for the help, you were absolutely definate in your advice, enough so that I went straight back out and took it all apart again. Not something to be undertaken lightly although I'm getting a bit of a dab hand at it now ;-)
  4. 0ptic

    Command - not working via streeing wheel buttons

    3 SOLVED! Took it all out again and realized it was intermittent. The little gray lever for the (canbus?) plug had a broken hinge and wasn't going fully home even with the lever in the right position. refitted the plug without the lever and it's OK. It's a pretty good fit so I don't think...
  5. 0ptic

    Command - not working via streeing wheel buttons

    I had another look this morning and everything is plugged in and no kinks in fiber optic cable. What I have since noticed is that the list of configured components has only one entry for comand. The list of actual components includes Digital BOSE AMP, CD Changer. and the TV doesn't work. I...
  6. 0ptic

    Command - not working via streeing wheel buttons

    If I go in to diagnostic mode it says "Ring must be open". I did remember plugging in the optical plug but I might have kinked the cable when I screwed the unit back in. I guess I'll have to take most of it apart again tomorrow and have a look :-( Oh well, at least I know how to do it now!
  7. 0ptic

    Command - not working via streeing wheel buttons

    Hi Folks I had to change the aircon flap levers today on my C32 :crazy: Horrible job but done it OK. After getting it all back together, I noticed that the command works OK on it's own buttons but not on the steering wheel buttons. It also used to turn off when I removed the key but now...
  8. 0ptic

    Rotten Smell from Headlamp Washer

    Had this on mine. Didn't notice a smell when filling the washer bottle but when I changed the headlamp washer pump it stank of rotten eggs :crazy: Just flushed it through with the pump out and refilled. I guess if the headlamp washer isn't used much the fluid in the bottom half of the...
  9. 0ptic

    c32 Torque converter probs

    Hi DrEv1l This can be a very subjective problem but, I live about 1 mile from where I work, and I'm ashamed to say I drive almost all the time :D After a couple of weeks of just driving to work and back I notice the GB starts to change it's behavior for the worst. Nothing too bad, just a bit...
  10. 0ptic

    c32 starting mpg

    I think if you reset the "since last reset" display and then go for for a normal drive you will see a more accurate display. I noticed a similar effect after a couple of weeks of short cold journeys, did a reset and it started creeping back up. I think the "since start" display started at...
  11. 0ptic

    2004 c32amg

    What the hell has been done to your car? I never see better than 26 even on a steady run! Remap??
  12. 0ptic

    How much do you pay for insurance

    C32 AMG. ~£530 with 6 years NCB. Had a company car before and couldn't get all the NCB. 48 years young. Thought it wasn't too bad considering how much some young lads have to pay for for a 1L corsa :crazy:
  13. 0ptic

    Go on lets here your favorite "Obscure" Records...

    Deus Been ill with that New York flu for over a week now. On antibiotics and steroids and this is the first time I've even felt well enough to listen to music :eek: Glad I found this though, had to be a live version as all the others cut the song short before that mad outruo. CngnUi490ew
  14. 0ptic

    c32 Torque converter probs

    OK thanks Billy. The guys Merc guys I mentioned were really great. They didn't seem too sure they could replicate the problem but they put it on the star and said some of the adaptions were a bit close to limits. They reset the gearbox adaptions and let me have it back to try out. It felt so...
  15. 0ptic

    Go on lets here your favorite "Obscure" Records...

    Happy new year everyone :D cPdVhjXHdfE
  16. 0ptic

    Go on lets here your favorite "Obscure" Records...

    :eek: Well that was weirder that I can even come up with, but I'll still drop in a bit of Holger Czukay. :D PyqkIr-1Vk8
  17. 0ptic

    Super Glue on Dashboard

    Cheap nail varnish remover (just acetone) will work too. Best test on an inconspicuous area first though. As DM said, an old toothbrush or something to work it in to the grain??
  18. 0ptic

    Go on lets here your favorite "Obscure" Records...

    I seam to have made a subconscious connection from a MTB vid I really like, so here's another one... mUm0ItSbavc
  19. 0ptic

    Go on lets here your favorite "Obscure" Records...

    Thank you!! Why have I never seen these guys before???? Utterly brilliant! :bannana:
Back
Top Bottom