Search results

Hi, My mirror glass seems to be unglued from the motor drive plate. How can remove the housing to refit the glass. I want to get it back in before I reglue it or is it clipped in. I cant seem to get it in the correct position for it to fit. Any ideas. Thanks

Hi, Thanks for your reply. Battery voltage is reading 12.8, charging 13.6 so these seem ok. Just started the engine and ABS, BAS/ASR still on but this time the roof works properly up and down. I too can not see a connection, maybe 2 faults, need the warning lights solved soon as she is due ITV...

I have an intermittent ABS and BAS/ASR error light fault. When these show up with the engine running my vario roof also wont operate, the switch lamp just flashes. The error lights sometimes go out whist driving. Any clues please.

Solved Thanks to all who offered advice. Yesterday the battery was low due to all 4 indicators burning all night when the relay failed. I charged it overnight and this morning all is sorted. Thanks again.:bannana::thumb:

Replacement relay fitted I have just fitted a replacement relay, indicators, hazards, wipers all work fine now. But ..... now the remote doesn't close the windows or set the alarm. Martyz you were spot on suggesting the big relay was faulty. Thanks. I am going to refit the old relay tomorrow...

Here are a couple of photos. Picture 1 shows the window inside the edge of the seal when closed from inside the car. Picture 2 shows the window when its fully up and the door is closed as it would be after one gets out. I have noticed that this is the same on both doors. Also, the windows do...

Maybe my windows are rising to high, with the windows up and then the door is closed the windows don't seal properly and then water gets in. There was a problem with the drivers window when I bought the car, the independent trader reglued a bracket on the bottom of the glass.

I have checked the battery voltage all ok. The problem persists even with the engine running. I have found the relays, there is a small square on at the back, an oblong black one at the front middle, I removed both of those one at a time and the indicators still all stay alight. There is also a...

Thanks for your reply. I was hoping there was a faulty relay. Do you know if the later models work the way I was hoping. If they do maybe there is a solution to be found there. Do you have the same issue with your slk.

On my 1993 300CE the windows close automatically when the alarm is set by the key fob remote. On my 1999 R170 SLK 230 this does not happen, should it. The way the windows closes on the inside of the seal I would think that when you open the door, the window should drop a half inch and when the...

Just been to the car and re connected the battery. The alarm sounded immediately, cancelled on the remote and all 4 indictor lamps went off. Tested the stalk and the indicators all came on again. There is a small red lamp on dash showing when the alarm is set. There is a slow clicking somewhere...

Hello Martyz, Thanks for your reply. Had a look in the fuse box but there are no relays in it. Tried setting and unsetting the alarm, indicators all go off and then come on again, also the alarm siren bleeps. Windows go un and down with repeated alarm setting as normal but still no normal...

Hi all, I have just bought the Autocom CDP+ diagnotics system. I have a 1993 A124 300ce 24v and a 1999 R170 SLK and am awating the correct adaptor to connect the cars to the autocom. I have found one for the R170 but not for the 300ce, any ideas where I can get one from please.

Hi guys, new to your forum, hoping someone can help. I bought my car 18 months ago as a project and have repaired quite a few things. Went out early this morning and all four indicators were lit, no flashing though. I thought I must have knocked the hazard switch last night, but switch...