valve

  1. Mo-benz

    Ipe exhaust valve doesn't open!!

    Hi all today i rather been quiet on the streets, this is due to the ipe exhaust valves not opening for some reason , I'm not a techy guy but want to know what could be the cause of it, it was fine the day before , and it stays off . You can still here the electronic actuator sound click that...
  2. karozza

    Anyone rebuilt a Valve Block??

    I have rebuilt mine 3 times & still not 100% happy :fail The car still drops on the front passenger side & for the first time yesterday, got the first warning; car too low in red. Would like to run through this with someone, if need be even on pm. I am now rebuilding another for a mechanic &...
  3. G

    W211 EGR Valve.

    Hello All, I have a 2006 W211 E280 CDi with 125k miles. There are no warning lights or fault codes. Virtually all the time I have owned the car, 2 1/2 years, 50k miles, it has had a sticky EGR valve. Has anyone successfully removed and cleaned one or will it need replacing. I wish I...
  4. T

    Air control valve

    My 1980 450SL is suffering from high tick over and running rich. I am told that is probably the Air Control Valve sticking. Does any knowledgable member know where I can buy a replacement or if they can be refurbished. Thanks
  5. S

    C63 AMG Fi Valve Exhaust - May Special

    We have now fitted several branded valve exhausts as well as custom and primary decat, secondary decat, x-pipe and any combination you like. If you want to maintain the rasp of the C63 but with added depth then these exhausts from Fi are the one's for you. High quality components and built to...
  6. K

    OM603 valve seals done and it knocks

    as stated done the job today, replaced cooper o-rings and washers, torqued up 30Nm, loosened, 30- loosened and final 35Nm. didn't disturb anything else down there as was really carefull. cranked it for some time without fuellines to clear debris. and now it is knocking quite badly?? why?? do i...
  7. karozza

    SL55 Front Valve Block

    Part number 2203201258-old part number 2203200358 Don't really need it yet but front drops 10-15mm after 12-24 hours & stays there so if a relatively cheap one comes along, might just buy it as a preparation!
  8. B

    V-class V220, fault code 1622 - switch over valve?

    Hi, does anyone know what the electronic switch over valve is and does? I recently had a new engine put into my v220, w638 diesel auto. The replacement engine is from a 2002 model and my bus is a 2000. The engine looked slightly different but I was assured that the block is the same and it...
  9. Bellow

    Valve stem seal replacement - the easy way.

    As per title. (Warning to the squeamish - language gets a bit FFFruity. But, ****, they get the job done!) https://www.youtube.com/watch?v=zFmC66YU6zI
  10. A

    Vito TPMS Can I just buy the valve cores?

    Hi all Trying to find out if I can just buy he valve cores rarther than buying a complete sensor and having to have it programmed back in. Any help/info would be great!!
  11. karozza

    SL55 AMG Valve Block Part Number

    Can anyone tell me this? 2002 model VIN:WDB2304742F027953 Front valve block part number.
  12. grober

    Peavey Bravo 112 valve amp

    A question for the "axe men " on the forum? Sorting out the loft decided this had to go. A PEAVEY BRAVO 112 VALVE AMP. Dating back to the early 90's it's had very little mileage since I bought it. Reputed to be a copy of a Marshall tube amp its a solid bit of kit in good nick ---its rated at...
  13. karozza

    Abc valve block??

    The front seems to be diving around a centimeter over night & stays there as for as long as it's parked. Does this mean a dirty valve block?? Is this at a dangerous stage as I have a long weekend drive to Sicily this coming weekend?? I think it's been doing this for quite some time. But, as I...
  14. R

    Return valve for hydraulic fluid pump

    Going to change the hydraulic fluid for my 1999 R129. I want to bleed the old fluid out by taking off the return line. Can anyone identify which one it is? There were no markings on the pump to indicate direction Thanks in advance
  15. benjy88

    Abc valve block repair kit?

    Hi everyone, my car has started to sag recently ever so slightly more so on the OSF and there are no leaks anywhere so am putting it down to the front valve block is sticking so gonna give a full clean and replace the o rings while there out. I have been trying to find high and low where I...
  16. P

    Split boot from EGR valve

    Hi everyone, Have got a split rubber boot on a line coming off the secondary air injection on my 1999 SL600. Am trying to find the part number to replace the boot (or the line if I have to)....cant seem to find it on EPC...help!? Piccy here: Thanks!
  17. J

    Vacuum valve operation???

    Hi Can anyone confirm that a vacuum control valve (EGR or Turbo) requires power to shut off vacuum, and passes vacuum with no power. Just want to make sure that mine are working as they should. Many thanks John 2003 S210 I6 320 CDI
  18. johnsco

    E300td - glow plugs, diesel delivery valve seals , etc

    I've been putting off a couple of jobs on my old friend for some time. 1. There's been a glow plug (maybe 2) not working. The car fired up OK, but with a fair bit of smoke and a stink of diesel and a bit of grunting and farting for the first few seconds. Unfortunately, one of the glow plugs had...
  19. J

    variable valve timing sprockets??

    variable valve timing sprockets, what are they. Mercedes says my w204 needs them?? whining on cold start for about 20 secs??
  20. F

    S211 - 722.6 - Valve body - numbers

    Hi! I need to replace my valve body on my 2004, E220 CDI. I see it is many different "numbers" on this valve bodies. Click on the link to see the different numbers under "description" and "stamp #0006" and further.. Transmission Valve body 722.6, 00-Up , Stamp # 0606 P78740-5 Someone...
Back
Top Bottom