Advice disconnecting seats on a 560SEC

[gbjeppm]

All

I am trying to remove the seats on my 88 560SEC, which has heated and memory seats.

I have disconnected the smaller cables, and the vacuum, but there is still a thick loom that goes into what looks like a circuit board covered by a big plastic shroud. There does not seem to be an obvious way to disconnect this and remove the seat from the car.

I have looked at the floor pan, to see if I need to disconnect the other end, but it is not obvious.

Anybody who has experience of these, advice greatly appreciated.

 

[gbjeppm]

Bump, anybody?

 

[jaymanek]

It's been a while but from memory it disconnects at the seat, it's a large connector plug

 

[gbjeppm]

Just an update, as I finally found the easy way

You need to unclip the carpet cover, by putting your hand under the seat from the rear and releasing the springs.

This then uncovers all of the power connectors, that makes the job easy, took me a while to work this out, so hope it helps someone.