Hi guys,
Rear wiper not working. Have dismantled motor and all looks good. Free moving and motor runs fine with 12v applied directly.
I believe the issue is the signal/power going to the motor or else the electronic module in the motor.
What voltage/signal should come through the three wires that plug into the motor. I have measured 0v for Brown, 12v for Green and 12.4v for Grey/Black. Switching on the wiper switch causes an intermittent drop in the Green voltage every 5 seconds or so. Other voltages unchanged. Does this sound right?
If it is, I suspect the module on the motor and if not, perhaps the relay? Fuse is ok!
Thanks for any advice!
Rear wiper not working. Have dismantled motor and all looks good. Free moving and motor runs fine with 12v applied directly.
I believe the issue is the signal/power going to the motor or else the electronic module in the motor.
What voltage/signal should come through the three wires that plug into the motor. I have measured 0v for Brown, 12v for Green and 12.4v for Grey/Black. Switching on the wiper switch causes an intermittent drop in the Green voltage every 5 seconds or so. Other voltages unchanged. Does this sound right?
If it is, I suspect the module on the motor and if not, perhaps the relay? Fuse is ok!
Thanks for any advice!