Home
Forums
New posts
Search forums
Media
New media
New comments
Search media
Members
Current visitors
COVID-19
Log in
Register
What's new
Search
Search
Search titles only
By:
Current visitors
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Home
Members
AndrewOl
Active Member
·
From
Romsey
Joined
Apr 1, 2017
Last seen
Today at 8:16 AM
·
Viewing thread
2000 grit wet sand and compound
Messages
529
Likes
195
Find
Find content
Find all content by AndrewOl
Find all threads by AndrewOl
Latest activity
Postings
About
AndrewOl
replied to the thread
Replacing 19” rims with 17”
.
Thanks for the replies. 17s are listed on the build sheet but at 7.5J ET 45. So the 8J ET48 should clear ok. It had 245’s on it when I...
Tuesday at 11:39 PM
AndrewOl
replied to the thread
W211 brakes failure
.
Hi Ben, have to say this doesn’t look promising. Before giving up though I would try a good independent. Main dealers aren’t interested...
Tuesday at 1:55 PM
AndrewOl
posted the thread
Replacing 19” rims with 17”
in
Wheels, Tyres, Brakes & Suspension
.
My 2010 A207 came with copy AMG 19 wheels that are not holding up that well due to poor finish and a magnetic attraction to kerbs. I...
Tuesday at 1:40 PM
AndrewOl
replied to the thread
'Positive control deviation during boost pressure control is too high' 123900 M642 engine
.
Bit of oil is normal as it comes from the pcv system hose.
Sunday at 7:42 AM
AndrewOl
reacted to
Paulhick's post
in the thread
Cheap Apple play solution
with
Like
.
I’ve not had any problem with it yet to be fair. If it does turn out to be shite then it’s a tenner wasted and not £500+(1400 for the...
May 9, 2022
AndrewOl
replied to the thread
E350 CDI C207 Remap & Service
.
Just recently mapped my 2010 A207 with the same engine. I used a generic map from someone whom I trust. Process is quite involved as the...
May 6, 2022
AndrewOl
reacted to
SmartAmg's post
in the thread
locking nut key and studs
with
Like
.
Leave the locking wheel nuts off, they are a pain in the @rse, When did you last here of anyone getting there alloys nicked. :) 👍
May 6, 2022
AndrewOl
replied to the thread
Om642
.
The swirl flap actuator and rods in in the v under a few other bits so you cannot see them as such. The top of the motor is just under...
May 5, 2022
AndrewOl
replied to the thread
Om642
.
If it is not leaking at the moment I would wait. Owning a +10 year old MB usually presents plenty of opportunities to spend your money...
May 5, 2022
AndrewOl
replied to the thread
Multimedia
.
That’s brilliant! Did MB tell you about that ‘fix’?
May 2, 2022
AndrewOl
replied to the thread
A207 wheels
.
My 2010 A207 was ‘upgraded’ from staggered 18’s to 19’s. Wish they hadn’t as the ride is shocking and they are prone to kerbing. Look...
May 2, 2022
AndrewOl
replied to the thread
Om642 intake manifold swirl flap motor
.
I don’t need the resistor in now as I mapped the motor out. Still need to keep it disconnected though as the motor is short circuit.
Apr 30, 2022
AndrewOl
replied to the thread
Om642 intake manifold swirl flap motor
.
Mine just went after 12 years and 80k miles. Not going to be easy to assess the life left in an operational unit. They don’t do a great...
Apr 29, 2022
AndrewOl
replied to the thread
2012 E350Cdi Coupe - DIY Service?
.
I believe there is a proximity sensor on the manifold that picks up the actual position of one of the arm. May be buried in the v so...
Apr 29, 2022
AndrewOl
replied to the thread
2012 E350Cdi Coupe - DIY Service?
.
If the swirl flap isn’t stuck then they are open when the motor is not operating. The motor usually fails open circuit which causes limp...
Apr 28, 2022
Loading…
Loading…
Home
Members
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom