Recent content by Gunnerkev

Hi Ronnie I have a vito that stores a similar charge movement flap code to yours Just mine says the adaptation or adjustment is incorrect or the emergency position was not reached. I haven't investigated mine as its not causing any issues but code is there everytime I hook up the fault code...

Sounds like a serious and unsual electrical problem there vitovan888. I have a vito as well but ive never heard of that happening. prob best to pay an auto spark a callout to see what the problem is or start to check the wiring around the starter motor and starter motor itself. Could be the...

Finally got to bottom of vibration although I suspected from shortly after the above posts that it was a damaged alloy with a bit of a flat spot. Finally got a set of different alloys and vibration is gone. it only happened around 60-70 mph bit like a out of balance wheel but hard to pinpoint...

Hi Cheddar, sorry didnt see this until now, It was showing 1 bar on the low pressure pump with ignition on and when cranking it showed 300 iirc. Would a jammed throttle flap cause it not to start at all? Just to add i drained the tank yesterday and new filter but still same symptoms. I need to...

3/4 filled it that morning chedder and than topped off the tank at a different fuel station about half an hour before it stopped. i had a miss on one cylinder just after i put the first fuel in. Not fussed on draining a full tank into jars but if i have to. This van has really broke my heart at...

forgot to add before i took old injectors out for recon, i cranked over the van for about 2 mins and when i took all the injectors out all were normal looking except the tip of injector 4 was wet

Hi all I have a vito starting problem. i broke down just before christmas, the van started pouring white smoke out the back and pinking or going off a cylinder or maybe 2 one day. i pulled up along the side and the engine stopped and would turn over but not start. felt as if it was hydraulising...

I have bought a icarsoft i980 fault code reader. i managed to pull numerous codes regarding low voltage to different circuits. I cleared most of them but they kept resurfacing. the reason i think they are doing it is because of another fault on the readings from the engine side. I have not...

Thanks Shoozz, at the minute my old vans in the shed as I'm doing a couple of things to it to get it ready to sell. Once its out i plan to get the vito in on the lift to check that out as i have read about the ujs and carrier bearings producing vibration when worn, Weather here not suitable...

Hi I haven't touched or examined my driveshaft or carriers yet. i have changed my rear tyres as one was buckled, and this dramatically improved the vibration. I don't feel the vibration in the brake pedal or clutch pedal either. My vibration is hard to pinpoint but feels somewhere in the region...

Hi Gtelee Did you ever solve this problem as it sounds similar to my W639. I suspected my DMF flywheel but not sure. regards Kev