Recent content by RogK

New pot installed. Oddly, at the most extreme angle possible, I can only get it to 5.6V on pin 1&2. That is literally the highest voltage reading I can achieve 🤔 It has cleaned up my idle alright, though I still got a case of the 'putt putts' round back. The journey continues...

Yeah, scribed before removing. I think the old one in the picture is a generic brand; I forked out for a Bosch from Amazon.de - €160 - so have high hopes for it. Should arrive in a day or two.

Gonna need more than colouring in with a pencil!

After seeing the state of my potentiometer, I'm amazed my car actually runs, never mind hunting at idle! Resistance and voltage were so all over the place, I thought my multimeter was banjaxed!

Really decent of you, thanks. I'm in Dublin though! (Or 'the other Liverpool' as a friend in work would say)

Well that was interesting. So far so good, running well. Slightly hesitant starting and hunting a bit at idle, but thats another thread for another day. New dual fuse OVP relay on the way so that might help. The guide rail pins tapped in tight with no drama. When pushed home they seat in a...

Good call there. Is Dirko the Elring stuff? It sounds familiar. I think when I picked up the head gasket set they threw in a tube.

I was thinking about achieving the same end by different means and using a small round file to ever so slightly increase the diameter of the hole, then as you say, fit the pin and epoxy it in

Here's how we're looking right now.

Food for thought. Nice one.

The bolt that led to the whole sorry story is not the bolt by the sensors, it's one of the three spline head bolts at the timing chain cover - the one that is slightly obscured by the timing chain guide as you're looking down the line of the timing chain. Bellow, as it happens I did plate the...

I know it's far from ideal, but for better or for worse, I jb-welded the front, got it flat and everything lines up. I figure if the repair stands up to hammering the pin in, it should be good for holding the guide rail. I asked the welder who looked at it about vibration and he reckoned if...

Really appreciate the help. I've bought from MSL before with no issues, I'll ask them for a quote on shipping, but I'm not too hopeful it will be economical. I'm also still looking out for a head locally. I tried a few guys who helped me out with stuff before, but they're not keen on breaking a...

That would be ideal - listing says doesn't ship to Ireland, but I'll contact the seller right now. Thanks for the tip, much appreciated.

I hear ya, I really do! I've made a few calls and I'm watching ebay and the small ads. But no luck - as yet - with an alternative head; and shipping prices and logistics across the Irish Sea are nuts at the moment. I might check with a pal in Belfast, could maybe get one shipped there. When the...