Recent content by seany260

Thank you for all the detail.

Hi, Anyone seen benefits of a plug in tuning box or remap on the w164 ml320. Can the gearbox be tuned? Sean

Hi all, New to the MB ownership platform and have got myself a ML 320 edition 2009. Looking for things I should check immediately and things I should be doing. Should I change the gearbox oil, if so what aftermarket oil is favoured? What is the recommended oil grade 5w-30? Look forward to...

That's what I suspected from pin6,12, but why does pin 10 exist on this e200 and why did it pulse out codes? what does a solid light means as soon as the yellow cable is pluged into 12. Thanks for the help, it's gratefully appreciated. Sean

What system is in the car? It was having cold start and idle problems in the colder weather. I checked all vac lines and they are ok. The 4pin coolant temp sensor is out of spec I think readings are almost 2k apart. Can't find anything to say what spec should be on the CTS. really I'm just...

I did try pin 8 yesterday and it only blinked the once! but then I found this document linked, on the end of page 4 and start of page 5 describes how you should read engine codes from an ez-l injection system using pin 8, my question on pin 8 is this procedure really necessary to activate a...

So I made a led flash code reader for the grandfather's e200. And here is what it brought up. Pin6- 2,3,8 'SRS' Pin10-8,13, roadsters soft top( not correct dosent add up) Pin12- staying on constant?? ( infrared remote) is faulty Only thing is the document that I'm reading off says that pin...

Its ok I've just made one.

Thanks, know anyone sells them here in the UK? Can't seam to find anything on fleabay.

Hello, what is the correct ohm readings on the 4pin cts. I read 1.8kohm and 4.5kohm on the pin diagonially . Car was just above cold, prob some were between 30-50 degrees. Also what diagnostic device is used to read these cars. Look forward to a reply Thanks

I think I can hear a slight vacuum leak, but can't seen to locate it. I'm going to strip that area out next week and see what I can find. With regard to the throttle body, do you know anything about all them linkages in there, seam to be quite some slop in there before the throttle actually...

Hello all, My grandfathers car is suffering from an idle control problem. I came about when the fuel pump went and for some reason the mechanic decided to clean the TB. from this the idle problems started. This car does have a sensor attached to the throttle body on the far side. It's also has...

Hello all, I'm looking for a MB specialist in Armagh, northern Ireland.I'm currently in the craigavon/portadown area. Need some important work done if anyone can point me in the direction of someone. Thankx

Quick hello and thanks to all the good posts. Driving a c220 cdi avantaguard with full sports pack.