Recent content by waisal

Many Thanks really helpful

Hi I am looking for a cheap set of OE rims for my W204 C63 AMG I am not sure which 18 inch W204 rims would fit the C63 anyone have any advice on which rims will fit Many Thanks

Thanks everyone it was normal thread! removed anti clockwise when facing the car SOB did not want to move had to wedge he pulley holder tool against cross member and jam on a slightly smaller spanner and hit with a lump hammer after about 5 hits finally shifted. Normal 36mm fan spanner was just...

Left Hand Thread? Sent from my SM-G935F using Tapatalk

Hello I have been trying for days to undo the Viscous fan clutch nut I have the holding tool and 36mm spanner but I am struggling. If I am facing the car which way to unlock the nut clockwise towards passenger side or anticlockwise drivers side I have also tried shocking it with hammer blows...

Thanks for thw response yep I thought so but also looking online these radiators seem difficult to source email so will probably be a Mercedes parts order and a few days to get delivered I definitely need a new radiator drain plug snapped inside I then tried to use a screw to get out no luck...

Hello I have a c43 AMG W202 my daily driver I need a replacement radiator part no 202500743 ideally today I am Manchester based can anyone help? Sent from my SM-G935F using Tapatalk

Hello Would you accept £300 Thanks

Hi My best offer is £350 are you happy with that.

Did the retest failed again due to CO 0.6 should be 0.3 need to check lambda sensors now. I think going down the CAT delete route these days is potentially going to make things difficult at MOT time

how do I check the sensors Sent from my SM-G935F using Tapatalk

my car is a daily driver so used almost daily according to MOT certificatedialed due to excessive CO but no reading given I will add some cataclean and go for a longish drive before retest Sent from my SM-G935F using Tapatalk

Hello I had my MOT today on my W202 C43 and failed due to emissions. I have had a stainless exhaust with middle CAT and box delete done about 3 months ago the CATs were past it anyway. Anybody in similar situation is there any fuel additive or other technique I can use to get through...

Hi Replaced seals today but managed to drop one of the oil cooler bolts and lose it anyone know where I can get a replacement quickly. Hopefully once I've got the bolts and all of them torqued correctly it should be the end of the oil leak. Sent from my SM-G935F using Tapatalk

Hello I replaced the oil cooler seals today due to a leak. A complete pain of a job due to the tight space. Unfortunately managed to lose one of the bolts. I looked high and low and could not find it. Anybody know where I can get a replacement quickly. Thanks Sent from my SM-G935F using Tapatalk