Search results

New motor installed and operating well. Now I need to put the door panel and have 3, white clips that I don't remember where they were located. Any ideas? Since I didn't expect this project to take this long and since there is a "HOW TO" on this website, I did not write down where each part...

Drive Gear missing teeth I found it is extremely difficult to install the regulator with the window in the full up position so I thought if I tried it in the down position the motor stress would be reduced allowing it operate. It moved a little bit and then stopped mid-position. I then took...

Update: Dec & optimusprime, I have the window up and can hear a slight air leak at speed so it's not fully closed but there are no visual gaps. I could live with it as-is. However, I have decided that before mounting the door panel I'll clean the relay contacts and then re-check the motor...

Dec, I checked the relays 5 & 6 for the passenger window and each responded to the appropriate switch position. The relays are sandwiched between two boards that can be separated to see the relays. Everything looked brand new in this 22-year-old car. Are there torque switches or circuit...

Dec- Thank you for your reply. I will check the relay and post back. BTW, I'm in the US so RF is the passenger window. I do not know if it had auto-down but if it was supposed to have it, it did not work. After removing the door panel I found the slide had come out of the guide that is not...

I'm having problems with the RF Window Motor. (see here for details http://www.mbclub.co.uk/forums/electronics/62149-howto-replacing-w124-front-window-regulator-saloon-estate-2.html) Using the above w124 link I found the wiring diagram but I do not understand enough about electrics to be...

Update: I wasn't not doing what I had described. I was trying to install the regulator in the wrong position with tension on the spring but with the window in the up position. I corrected that error but still cannot get the three studs to line up with the holes in the inner door plate. I used...

1993 300E The front passenger window would only go down a few inches so I kept trying the switch. After a few attempts, it wouldn't go back up. I think one of the guides had popped out of its track. Rather than replace the entire mechanism (motor/gearbox/pinion gear and scissor lift with...