Search results

I have a 2007 om646 evo which the brabus d3s fits

Well after 18 months of trouble free motoring I noticed the rear lights were really dim and smelt burning you guessed it both earths burned out connectors melted rear lighting clusters burnt ordered two clusters and connectors from eBay shop Mercedes Newcastle £37.10 each got 21amp brown cable...

Hi guys Car running well with no problems Car is 12 years old 87,000 miles om646 Did a b service and on checking the serpentine belt. It has small cracks on the ribbed section I already have a new spare so will change it shortly ,as I have no noises coming from the front end I will...

Got a reply from brabus On the d3s the gearbox setti gs don’t affect the power extra From my experience so far I disagree lol

Hi mate when you fitted your d3s did you get any info on the auto box modes and how they affect performance of the brabus box Hope you can help S

hi guys, Have emailed brabus but no reply as yet, Does anyone have information on how the brabus box is affected by being in C or S or manual mode on the auto gearbox On S and manual mode it idles slightly higher, C appears to tone things down, Haven’t been able to find much info on...

after having to sort out the loom and prepare for fitting by fitting new injector plugs(£4 pounds each from Mercedes dealer,) old locking sliders had fallen to bits Fitted loom to engine bay Fitted module and connected up Powered up all good and green led flashing Warmed up and taken for drive...

Hi stardelta Which way did you pass the temp sensor cable down to fit under the car Fitting mine on saturday

My OCD method for a fuel filter change lol On fuel fill up prior to filter change get a couple of litres of diesel in a correct fuel container I changed my fuel pipe clamps from original ones to 304 stainless steel fuel clamps inlet 14 to 16mm outlet 11 to 13mm or reuse original clamps (race...

Sorry for my simple requests for assistance, Guess I should explain,I have bad arthritis in my hands and have to use tools to do things rather than my hands ,which if you don’t get things right it’s really easy to break things lol I was injured whilst in the military and am rather stubborn so...

Hi guys, Am gradually sorting all the connections ready to fit the brabus d3s Two left Injector electrical connection(see photo) Any ideas how to remove,think black tab must slide reward then compress two side wires to release connector ,but I can move them at all Also the boost...

Fantastic many thanks

Hopefully this photo will load

Hi do you have an email address I can send the pic to as I’m unable to upload to the forum, Many thanks Steve Diamond

So I’ve got already to fit my brabus d3s box to the car and whilst doing a dry run with the cables laid out I haven’t the faintest idea of how to remove the connectors ,all Delphi with a small gray tab, Any ideas.? Do I need a tool to remove them Don’t want to force them as I just know they...

Sorted found. Some of the connectors on diesel components uk Have emailed them ref the locking tabs Result

Got a jewellers loupe and have managed to get the rolling info off the connector FCI. PBT GF 30 240 PC 02488014 Hopefully the plug comes with the locking tab and rubber washer Am searching the internet any help greatly appreciated

Have had a look can’t see the sort of connector I need I’m going to need to buy the connector block and locking tab as two of my connectors are missing the rubber washer to seal the connector to the injector Have tried to upload photo but am getting file to big message I assume the brabus loom...

Lol yeah should have got that one