Search results

Mercedes 190E 1989, just changed the front wishbones and the usual issue that it's riding high, so I've read that the camber angle needs adjusting and is done on the passenger side only? This would make sense only the steering wheel isn't horizontal anymore, more like 45 degrees, so I've found...

Asking here, i'd sooner avoid ebay if I can.

Hi, i'm looking for an air filter housing like the one shown, must be in good condition please with all brackets present. Please pm if you can help. UK p&p required.

Thank you all for your help and no, I wouldn't touch it, that would be down to the garage if it needs.

I have an 1989 190e so to confirm I'm going to have problems and would it be wise to sell the car on which I would be loathed to do.

Update: No help from Mercedes available :confused: I wrote and had a reply from a Brian saying ; I have checked all the Mercedes Benz systems we have access to and unfortunately there is no longer any information listed for this vehicle. I have also checked our internal systems and can find no...

Apparently I need a set of wheel nuts specifically for a 190E Sportline, they have the longer head.

Yes, too shiny and they look too small to me, I've seen some standar steel ones which look far better against even a refurbished alloy, if the wheels were shiny chrome then they'd be fine. yes, i purchased the ones i have off the ebay just to check they'd actually fit and not go through and...

Total blush, I copied and pasted the size off the listing where I bought them from thinking M12 is the size.. A friend has laughed and said no, it's 17mm.!!

Sorry, i wasn't being rude, i had to purchase an item before after they had said which part i needed, it was ordered from Germany and took a few days or so to arrive, when it arrived it didn't fit but he stipulated there was no return on the item even though i purchased it over the phone...

M12x1.5 thread size (40mm long) are what I've purchased to to check fitment.

There is a reason why I asked for advice on here, no disrespect but the route of going ot my local main dealer at the moment is enough to put me off for life, besides, they're not always as helpful as they could be especially when they have a bogus returns policy. I was linked to one place...

Hi, I've asked elsewhere and i'm still unsure but these wheel bolts look tiny in comparison some, the car is a 190E, I've had the wheels put on just using 4 of these bolts and they fit and operate like they should, for me, they just don't look right so I've been looking for the non shiny...

That's brilliant, Thank you so much! Please don't, i would be likely to try the number too 😂

My Reg number is F117 TAC

Ok, so now i'm confused only reading this is why I thought that the AC was Coventry: What about old number plate area codes? Since our new number plate system has only been around since 2001, it’s not uncommon to see older cars with ‘prefix’ number plates. These types of plate are a one...

More than I wished for, Thank you so much! I shall check again regards my Reg, it's a 1989 190E

Hi, I've been trying to locate the dealership who supplied my car when it was new, on the other forum I was advised that the two second letters gave your area which is AC so Coventry right? So, I've searched and can only find Inchcape but as far as I'm aware they were not the original Mercedes...

I have used 7zap in the past to get part numbers but their site has gone silly and i can't get to see anything, does anyone please have a link to somewhere else that shows all the part numbers etc?

As per the title, please would anyone two of these clips / brackets, I don't even mind if they're second hand so long as they're complete, please pm me, mine were broken following a slight bump at the front.