Search results

Brought another antenna still the same

Hi I have unplugged the whole unit and changed the antenna in case that was at fault but no good still not right

Hi guys a new issue has appeared it thinks im 40 miles north of where I am is there a reset ? Or can I recalibrate it some how ? Thanks in advance its a 2006 CLS

Hi guys a new issue has appeared it thinks im 40 miles north of where I am is there a reset ? Or can I recalibrate it some how ? Thanks in advance

Hi I have no idea which is for which I was just going to remove mine and send to ecutesting they do a life time repair

Hi yes I am 1st scan said left rear inner changed the sensor now no fault scanned ? Any ideas ?

Hi reference the reverse sensors not sensing anything anyone got any ideas as to the problem ? Doing a scan shows no faults. Select reverse and on the rear come up the distance led lights 2 green ones and that's it doesn't matter how close you are they don't change. I'm lost with it now

Are you going to get another ?

Hi no I'm living with it at the moment will get it sorted eventually

Thanks I will do Jon

Thanks for your reply i have ordered 2off 4.7k ohm resistors (1 spare) thanks Jon

Hi i removed the inlet manifold on my 2006 CLS 320 CDI and found this plug unplugged decided to plug it back in refitted the inlet manifold only to find it would rev beyond 3000rpm i done a scan and came up with the following Inlet port shut of motor position fault. reset the fault removed the...

With regards my revese sensors I've replace a couple thought all was working OK done a scan with the diagnostic scan no codes found. But the sensors aren't sensing anything so I've no idea what's wrong not sensing and showing no fault codes when scanned. Any ideas ?

Hi my CLS W219 has the glow plug light stay on for about 1 minute after starting. I purchased a diagnostic tool and ran a scan its come up with cylinder 3 glow plug open circuit. My question being which is cylinder 3 (I'm guessing left hand bank rear one as I'm looking at the engine from the...

Hi I purchased a diagnostic tool and its telling me left rear inner ( check plug and or wiring) I've changed the sensor but still have the same issue any ideas as to the issue. Thanks

Oh no hope you are OK. Thanks for the update. Mines gone in to have the bumper fixed I didn't know the reverse sensor (one on the corner) wasn't working doh and cracked the bumper

Any joy with your repair ? i found the following https://www.ecutesting.com/product-catalogue/mercedes/e-class/gear-lever/glv670124/ if this helps

ive just ried the same thing as you and have the same I've found if my foot is on the brake I cant select reverse. If I move to N and release the brake I can select reverse without having to stop the engine thanks Jon

hi let me know how you get on. how much did you pay for your code reader ? are these the only code readers that work on mercedes ? i looked at some used modules on ebay and some of them say may need coding to your vehicle. a used module is about £90 so i hate to think how much a new one is...

Hi Thanks for the information this sounds expensive is it something that is plug and play or does it need coding and setting up ? where abouts is this located on the vehicle ? thanks Jon