Search results

Thanks for the advice guys, my indy did have a diagnostic, so he's seen oxygen warnings, but unable to see anything amiss in the engine. So eventually after driving it hard on the motorway for 20 mins, he believes the issue has being pushed out through the exhaust. Not sure what it could have...

Forgot to say, it's a petrol 2 litre and manual gearbox. Thanks, LK.

Hi Guys, Over last several months, my W208 has infrequently stalled, during light traffic. My trusted indy couldn't see anything amiss during it's service. Since then, and after doing a long trip during the weekend, it's has noticeably started to lurch and stall during slow traffic. On...

Problems getting the blower back in Thanks for the HOWTO! The garage said that my blower and regulator needed to be replaced (W208). After following instructions from the HOWTO the job was relatively straightforward. The only thing that's an issue is that I can't screw the four mounting torx...

This is starting to bug me, are the interior lights meant to come on my 2000 CLk200 W208 when I either unlock or open the doors? Is there something that can control this? Thanks. LK.

Bump........no-one knows? :(

Folks, Need a bit of help here, I'm getting a canbus adapter for my Bluetooth Parrot hands-free unit so that I can control it from the steering wheel. It's called an Audicom SW101C, and it works with a Parrot MK6000. The list of adapters is...

A bit of good news I found a automation specialist, that was able to fix the problem, apparently the cluster can loose its programming when disconnected. He had to "recode the module and reset". Everything is back to normal. :bannana: I never did get those pixels back up working though, I...

Disconnected battery for 5 minutes. No joy......I think I might have to shell out for a new cluster.:devil:

Just went out to try that, and forgot I didn't have the spanner for doing that. Will try that out when I get home this evening. Thanks.

Still no joy Well I took out the cluster, rechecked that everything was connected and looked for anything amiss. Put the cluster back in, and still getting the following errors: see pictures.... The engine temperature, speed and RPM gauges are dead. Fuel gauge still works. Also my command is...

Still working on it, does disconnecting the cluster without disconnecting the battery first a bad thing? LK

Hi All, I'm trying to follow MartAD's guide on my W208, but I'm not sure how much access I need to give myself to adjust the ribbon cables. Am I meant to seperate the PCB from the dials? I disconnected the main center ribbon (bad idea :o ), reconnected and am getting the same issue as...

That's the bulb I used to replace the broken one. I used a hair plucking tweezers to get the bulb out. It was alot easier getting it out once I snapped off the opaque white plastic cover over the bulb.:D LK

Replacing bulb behind airflow direction dial in a W208 Folks, Has someone done this fix before and figured out what part is needed to do this? I'm not sure where to start. See below picture of where the bulb is......

When you switch gears into reverse is there a beep to show the system is on? Or does it only beep when it detects incoming surroundings. My wife has it and it's incredibily annoying when she goes into reverse and it beeps for two seconds even when there is nothing close. LK

I used an LED, it's very clear if its working or not. LK

I'm considering getting the command 2.0 for my CLK200 W208. I'm just trying to make sure that there is no way of putting in a better (i.e. DVD based) MB navigation into my car. So...is the command 2.0 the best that will fit, assuming i want to keep cluster and steering wheel integration...