c250td

Hi all, I have a problem with a leak on the IP, within 20mins of stopping air will somehow get into the pump causing start up to be a right pain. It is not the fuelines as I have replaced the orings and i have stripped and replaced the shut off valve orings too. I am looking for any...

Hi all, When the car is at idle and I put my foot on the brakes the engine really seems to struggle, would this indicate a vacuum problem? Thanks in advance, Pete.

Hi My 1998 C250TD w202 has developed the weirdest fault. When I start the car, the rear offside passanger window opens about an inch! Its only been happening for about 2 weeks, I cant think of anything I`ve done that would cause it. I have found a blown fuse in the boot (number 7, 5A) which...

Hi, I am looking for the wiring diagram for the above engine, I would like the EGR/boost control circuit back to the ECU if any one would be kind enough to share it with me. thanks in advance, peter.

Hi all, The madness continues. I have in my possession yet another 1969 W114 250CE. The current engine is shot. I want to install a Diesel engine to run Biodiesel. I am looking for an everyday car. Doing about 80 miles a day. I am hoping the simplicity of older running gear is going to give...

Hi, I am looking for a diagnostic scanner for the above engine but before I purchace one I would like to know if anyone can recommend one? I have read about MBStar but it is well out of my price range and I am only after basic P codes as the EPC light is on. I know the plug is the round...

Just looking for some info on the timing marks for a OM605 engine. I have the crank at 0, the two marks on the cams across from each other so the pin fits it. However the engine locks up when trying the turn it by hand? Any help appreciated. Thanks

Hello all, I have an intermittent power loss problem with my C250td which brings the EPC light on. When the light is on the cars acceleration really suffers, I have given the air temp sensor a clean, checked the vac pipes for splits, checked the Map sensor with a multimeter and given the...

I've been having problems with my C-Class starting. After visits from a couple of mobile mechanics it has been diagnosed as a problem with air getting into the fuel lines. The first mechanic replaced o-rings and pipes in the engine compartment but the second mechanic says the problem is with...

Hi folks.I've got a 98 c250td and recently replaced all the clear pipes and o-rings ,prefilter and the seal and also the shut off valve seal along with 1 dv seal which was leaking along with 2 of the leak off pipes which were leaking. Theres still bubbles in the pipes and the car will fire with...

hi where is the cat on a 97 c250 td, thinking about gutting it, or replacing it with a replacment pipe, anybody got one of those diagrams to find it expected it to be on the downpipe, nothing there.. theres two boxes a small one and a large one in the middle of the exhaust system, is one of...

hi i'm about to attempt removing the inlet manifold on my c250td, full of oil and when on boot its blowing past one of the o-rings . picked up some new rings from the dealers - i asked for 5 - they said i need 10. are there any watch outs on manifold removal , other than dont drop anything...

Hi all, I'm selling my trust worthy C250TD! So thought I would post it up on here also as I'd love to see it go to a good home! Its currently @ 144,000 miles Automatic Full Service History Good tyre's & Brakes all round MOT till 2012 TAX till 30/08/2011 For more information please see...

As title suggests, Would one of these be suitable to fit on a om605 engine as its a bugger to start again after touching the fuel system!! Just thinking it would help in future with servicing, while also saving the battery and starter!! 10mm Fuel Primer Bulb Petrol Diesel inline non...

Thought I'd put a few photos of the c250td up. New summer wheels fitted. With the old wheels that are now being used as winter wheels with winter tyres. As it looked the day I picked it up, all those years ago now. I'll add a few more photos as and when I get a few more of...

Hi all - I'm after a bit of advice! I recently bought a 1999 W202 C250TD Classic - my first Mercedes. I have already done 7,000 + miles in it & am very impressed. As with all 'older' cars previously unforseen faults are bound to appear as you settle into ownership & get to know the vehicle...

Hi all I'm after a bit of advice in connection with a problem I had for the last week getting the car running. First attempt to start the car in the day results in having to turn the engine over for a minute or two before it struggles into life. Glow plug lights come on and go off as they...

any one tried this little modification on their om605 or om606?full load increase electronic governor

iv not long bought my 2nd merc, 98 c250td esprit auto, the speed limiter function is working but cruise doesnt seem to be, it did work but only stayed on for 3o secs an disengaged, and handy fixs or advice, thanx

Hello, I’ve been looking at getting my C250TD remapped. All websites quote similar figures of improvements in economy and performance so I’m trying to find the best company to go with. Has anyone dealt with CCC Tech before? Any help appreciated. Thanks