egr

Hi I'd like to delete the egr on my S211 3.0 CDI. My car has already been remapped will it need mapping again? I have a OB11 scanner- can I use this to delete it or do I have to use Star? Thanks Jon

egr revival... the before and after images... before: and after I cleaned it: the DTC was devolving the P0402 code... hope this is all it takes to sort that out...

the other day on m25 having to slow quickly , when traffic moved on car wouldnt go above 4th gear , even trying to use manual opt. Switched off / on and was fine. Car in for service ( @ MB dealer) yesterday & on pick up i noticed the same problem so went round the block and left it running ...

Hi guys, new to the forum and just wondered if anyone was clued up with EGR valves ? I have a Mercedes ML320 diesel 2006 model and it has had a intermittent fault with it going in a limp mode type state. Say about once a week it will have limited revs and feel sluggish. I did try to...

The EGR valve in my S-Class is firmly stuck in place -- barely moves a mm with all sorts of belting and hammering, and apart from the two screw holes there is not much to get a hold of. Is this normal? Does the fact that it is so stuck in place indicate that it is clogged up with carbon?

Hi, I had a leak on the feed pipe to the EGR, it required a new gasket. Whilst repairing this issue I noticed, oil in the intake pipe (after what I believe is the PCV); also in the pipe going into the intake manifold and inside the EGR. At there was enough oil, so that when the EGR was...

I have noticed a few tuners offer an egr delete with a tune for the om642 engine, my question is, if i do the egr delete and tune, is the egr disabled or does it require something mechanical like a blanking plate. Thanks in advance guys

Hi, i have posted on here a couple of times. Is there anyone on here that can make up the circuit for the EGR cut off for a 2003 CLK 270? or and fit for me. happy to pay, thanks in advance. Martin

Hi Folks New here please be gentle! I have just have the week from hell trying to get my EGR sorted. Initially the car was in limp mode and the inlet motor flap needed replacement according to STAR, this cured the limp but massively increased the smoking, the indie discovered a ball bearing...

Anyone give me a rough cost to take off my egr on my e320 cdi and clean it , how much am i looking at ?

Guys if you change an EGR valve on a V6 CDI do you need to programme it?

hi im asking this question to you learned people , could my egr be coked up , my car a e320 il 6 diesel has spent the last year of its life , mainly being used around town , and spends a lot of time just idling . I dont live anywhere were i can give it a long run and the nature of my job which...

Cleaning my 05 c270 EGR and cannot get the valve to operate by sucking on it. Appears to be stuck. How much vacuum or force is needed, I don't want to damage it.

I have just taken out, cleaned and replaced my clogged EGR valve and manifold. Whilst doing this i had to remove a few electrical plugs. There is one left over and after about an hour feeling around, i cant find out where it goes! The Oil Level sensor warning has lit up in red on the dash so i...

hi all I'm new to this.. but desperately need help. I've got a egr fault code, i get epc message on the dash I've taken the egr off gave it a good clean sand cleared the fault code, car drives luvly, when i drive around no fault code i bring the car home the fault same fault comes back epc...

Hi all Can anyone tell me how to block/bypass the egr valve please. Many thanks len

I just spent a good 2 hours replacing the egr valve assembly on my C270 cdi. Over the past 12 months or so I have spent around 80 quid on various cleaners: Revive, Wynne's egr 3 etc... The amount of oil and crap in the valve I removed was unbelievable, so much for miracle cleaners! Conclusion...

As per title, required for facelift 2000 model, part no. A6130980117 Must be fully working Thanks

I had to creat a new post as I cannot figure out how to PM attachments!! This is how I did my 2005 CLK EGR delete. I disconnected the EGR valve on the RHS of the engine and jammed a 5W 1Kohm resistor between the 2 pins on the connector. I sealed both that and the valve connector with tape...

as title, my car is making a really weird whining noise when revving, it sounded like it was from the egr valve, so we disconnected the plug on the egr and the noise when. any idea what this could be and is a egr delete the best way around this.