melted

  1. P

    CLS 320 CDI - 2006 | Melted Fuse Box | No Rear Demister | No far Remote Locking

    Hi all, My remote locking doesn't work very well at all in my 2006 CLS. It works at nighttime, close up to the handle (presumably infra-red frequency) but not during the daylight at all, and never from far away (presumably radio frequency). It's not a key issue. I noticed a melted fuse...
  2. R

    W209 CLK Xenon melted! *PICTURES*

    Hi, a friend of mine has a w209 clk and recently the passenger headlight started flicking and eventually went out. We went to go change it and found the actual connector and bulb had melted! Has anyone actually seen this happen before? The bulb was recently changed 3 months prior to this with a...
  3. Y

    Melted fuse box

    Heater fan stopped working this morning on my e320 w124. Found the fuse has melted into the holder at the base. Any repair for this or is it a new fuse box?
  4. Pittsey

    W204 Earth Wire for lighting Melted

    So... I had the earth wire issue with my W204 C Class on the passenger side rear cluster. Melted about 30mm of sheathing, the connector and the base plate. I bought all the new bits and set about taking the pins out of the old connector. Now it's been about 3 years since I have been on the...
  5. zenman63

    Vito/viano melted alternator wire.

    Had a few problems with my Viano, coming to a halt with the the red charging/battery light on. I when straight to the alternator and removed it, its a mega job on the V6 as it come out the front. Changed the regulator and refitted, same problem. Removed it again and exchanged it for a rebuilt...
  6. M

    melted 40 amp fuse

    I`ve just been checking my fuses because my drivers seat has stopped working (1999 clk) found a melted 40 amp fuse and casing in the boot compartment. Has anyone come across this before and a cause? Will it affect my drivers seat? Thanks
  7. sdp1075

    Melted Engine Bay Fuse Box

    I have just bought a 1998 c240. The blower fuse which is located in the engine bay had blown. I replaced it but only to find that half our later it melted my fuse box. Does anyone have wiring diagram etc so I can sort this problem out please? Thank you!
  8. chrispy2005

    2002 W203 Melted Wing Mirror Glass

    The glass on my drivers side wing mirror looks like it has melted from behind and after a phone call to my local Mercedes indie i've been quoted £300 to fix it (he says it's an auto dimming mirror). When I asked him about just replacing the glass with a regular plain one he said it might not be...
  9. C

    Melted heater plug in CLK270. Options?

    My lovely 2003 Merc has a melted heater plug which the main dealer tells me is difficult to remove without the risk of breaking it. They tell me if it breaks then the repair cost is likely to be £700-800.:( This sounds excessive for what to a novice sounds like a simple job. I am really...
  10. T

    CV Gaitor Melted!!

    Evening All, I am needing to change the outer CV gaitor on my ML270 W163 as i got a bit over enthusiastic with the blow torch when trying to get a snapped front anti roll bar bolt out. :doh::( My question is can i just remove hub nut (easier said than done) and then the top and bottom...
  11. BlackC55

    Melted brake wear sensors after trackday

    I have just got the C43 in to do some routine maintenence and took the wheels off to do a brake fluid change as the trackday can be harsh on the brakes. I have melted both the front brake wear sensors! This is a first for me!
  12. M

    w124 blower problem - fusebox melted in #12

    Hi I have the problem with the melted fuse cup/holder on no#12 fuse. Does anyone have a How To on this as I understand the solution is to fit an external fuse? How much would an auto electrician charge for this? cheers matt
  13. abbos

    w202 headlight wire melted!

    Hey everyone, Bulb went recently and I managed to have a look last night. Basically the plastoc connector that pushes on to the back of the bulb seemed to have melted itself on. I huffed and puffed but couldn't get the bugger off. I ended up un crimping the wires from the push connector...
Back
Top Bottom