pipe

Hi, due to the cooler pipes rusting thru I think I lost most of the ATF in the gearbox (98 C280 722.6). I drove about 60 miles experiencing the usual symptoms, losing drive, flaring, not selecting any gear etc. I topped up the levels but noticed a burnt smell coming from the filler pipe. Have I...

I have a c250td estate, the pipe from the inlet manifold to the top of the turbo keeps blowing off under boost, any idea's?

Just replaced the battery on my trusty (or is that rusty) E240 estate (210 series), and have noticed that there is no breather pipe on the battery. Battery is located under the rear seat and there would appear to be a hole for it to go out off in the floor. Should it have one, if so, where can I...

Afternoon all, the next think on the list is to change the ball joints and link pipe as shown as number 92 in the attached picture. Do you chaps have any idea how much this part is at all (from both Merc & alternative supplier)?!

Evening, Can anybody tell me what angle the middle section box join pipe (the pipe that joins on to the back box) comes out from i.e. is it angled to the left or the right? i have a rear sebring back box which is made just for the 220 and the pipe which is to attatch to the centre box angles...

Hello everybody! I'm a proud owner of w201 190d (2,0) I had a problem with a heating matrix and when I tried to put everything back in place, behind speedometer, I realized to have a black vac pipe loose and has no place to connect. I checked light switch, has two pipes already, heating...

Hi guys i have autoglym metal polish which is great for the most part of cleaning the tail pipe trims but on one pipe on the inner edge i have black deposits that are hard to remove with metal polish and cloth. Does anybody have a better way to get that off without scratching? Thanks,Andy.

Anyone know where I could get the front section of an exhaust for a w124 300d 1992 model? Non cat and with the flexi section in it. The car sounds like a tank!

Looking for a front flexy/ rubber brake pipe for a E300TD. Cheers.

For some time, I have been thinking about making my CLS 55 sound a little more V8. It’s too quiet at lower speeds (almost inaudible in town speeds), and properly audible only at quite high engine speeds. I heard an E55K (Adrian’s) at Bluewater which had had its center silencer removed –...

Have been told my rear brake pipe has some slight corrosion... very minor but been told to clean it up before it gets worse as it just starting to show. Whats the best way to do this? and to ensure it does not come back?7 Struggling to understand why a 4 year old would suffer from this....

alright, the cold air feed pipe as i dont actually have one :) cheers Brett

I recently replaced the parts seen in the photos below including the pins as these were saturated with oil.However after 3 weeks of driving I seem to have a film of oil over it. So I have a couple of questions that I would be grateful if can be answered. This end pushes onto a metal section...

Hi everyone, I've just noticed this tape around a pipe under my bonnett in my Mercedes-Benz A140 (2000). Any idea's what it is and how much it would cost to fix and is it anything to worry about? I can only presume that there must be a hole or something. I have circled it: Thanks!

Driving home in the fast lane I experienced a bang followed by a cloud of white smoke out the back. I then lost power although the car could be driven. I believe it went into LIMP MODE. Could only get up to 80mph max.... Anyway looking under the bonnet when I got home I notice that a large...

There is a little oil leak on the pipe going into the turbo from the engine as attached photo. It is not sealed, I could easily take it off when the engine was running; only oil vapor comes out of the pipe like it is breather pipe, not oil with pressure. I assume this oil vapour is leaking but...

hi just wondering if anyone can tell me where the vac pipe off the egr valve switch/actuator goes its conected at the egr end but it is hanging loose at the other i dont know if someone has done this on purpose or dislodged it i just dont know where it goes please help?also car hesitates...

I have made a de-cat pipe for the 210 E55 saloon. The sound is wonderful and quality is perfect as usual.

Hello, I’m looking for the exhaust flange off an E320 CDI which fits up to the turbo. If anyone has an old cat please let me know? The flange is 4” diameter so I’m not sure if other models are the same. I just need the flange really but let me know what you have. Any...

We have just made a de-cat pipe for C55's It sounds truly amazing.