These days I was wondering about sprintbooster and/or remap my car since a little bit bored and...till know bullet proof engine:mad: today I changed my idea
How is possible that the plastic pipe (not the following hose to the intercooler) can be destroyed in this so easy way? I was only...
Hello all.
I will keep this as brief as possible.
Are your headlamps still looking like they did the day they came out of the showroom? Are they looking a bit sorry for themselves? Spoiling the look of an otherwise very well looked after vehicle? Mottled and patchy or looking a bit yellow...
these are trims where the electric switch slots into so that it can fit into the door card, biege is good but any colour will do for now!!.
it might be the same as in w126 but not seen one recently to confirm.
I need to repair a hole in the rear bumper. I plan to remove the bumper then fibre glass behind then a layer of filler to fill the hole - which is about 5 cm by 2cm. A few years ago I used Isopon on the front bumper and it has held up well albeit with a very small crack line where the filler...
Hi all i need the clear plastic cover that goes over the gear selector print, if anyone has one or knows where i can source one from please let me know.
pic attached.
Hi all, Ive noticed that the plastic trim on the rear quarter panel of my 208 CLK is coming loose. ive had a little look behind it and from the looks of it the fixings that should be on the car are stuck to what looks like a bracket the trim. Dose anyone know how i can remove the trim so i can...
hello everybody im lookin for a set of wheel arch extensions NOT CROME and im not havin much luck finding some can anyone help me please my email address is ([email protected])thanx:dk:
How does the black plastic/rubber strip come off on the underside of the doors on a w203 c class.ie want to remove them to give a proper clean and waxoyl.
Alright peeps,
On the 202 behind the headlamp glass the is a rectangular light grey piece of plastic. Looking for a spare set to paint up as mine have yellowed terribly !
Anyone got anything
Cheers
Brett
Hi, does anyone out there have a 124 series they are breaking? I need the plastic cover that goes behind the battery and protects the 'brains' of the car from water.
I am sure that all 124's have the same bit of plastic, it is not model specific, though for info mine is a 220 estate...
As title mention, what´s the use of the black plastic valve on the top of the cam cover on a C270 cdi engine?
It´s the end of low pressure fuel lines.
When i had to change 1 fuel line i had a lot of problems in bleeding the system, and i wonder if it´s a bleeding point
Thanks
I am looking for the plastic bits that go around the sides of the front seats / runners on a Merc w126 (1988 300se S-Class). The seats are manual there are 4 pieces in total, 2 for each seat and I preferably want them in 'Hennarot' Dark red, but would consider other colours.
Please PM me if...
Hi
I have a scuff on the hard plastic back to the drivers seat ..3 inches long not deep ...you can see it is marked though- any ideas how to repair....caused by little folk and hard shoes- thanks
Hi all,
the right hand side plastic trim panel on my drives seat has broken at the front (where it joins the drop-down panel) and my attempts to glue it etc have so far failed!
Has anyone else encountered this at all? I will try, but doubt that I will get one from a breaker as seats, I...
The clear plastic display plate has a light crack, not to mention many scratches. I was wondering if I could replace just the clear plastic plate, and the procedure for the same if possible.
Thanks in advance.
I have been looking for a rhs plastic undertray the one which comes from the rhf wheel arch liner to half way down the car and it meets the centre tunnel covering does anyone have a part number for this part or a diagram so i can show my local dealer
regards
rich
I require the n/s plastic panels that are attached to the bottom of the front and rear doors and the rear arch. The car is in brlliant silver therefore the panels are a slighter darker grey.
You do have to look very hard to tell the difference however this is my project so I want it to be...