plastic

The clear plastic display plate has a light crack, not to mention many scratches. I was wondering if I could replace just the clear plastic plate, and the procedure for the same if possible. Thanks in advance.

Hi, Really appreciate some help. I think there's a problem with the waste on my sink as it takes ages for the water to drain from the sink, and no amount of unblocker will help. So I've decided to replace the waste, seeing as they don't cost to much. However the waste is stuck solid, i...

I have been looking for a rhs plastic undertray the one which comes from the rhf wheel arch liner to half way down the car and it meets the centre tunnel covering does anyone have a part number for this part or a diagram so i can show my local dealer regards rich

I require the n/s plastic panels that are attached to the bottom of the front and rear doors and the rear arch. The car is in brlliant silver therefore the panels are a slighter darker grey. You do have to look very hard to tell the difference however this is my project so I want it to be...

Hi and thanks for looking, This has cracked and I don't fancy taking it into a MB dealership to get replaced. Any ideas on where I can source the item and get it fixed without having to pay £140 per hour labor rates? I'm in the Manchester area so anywhere around here would be good. I...

- when the engine is turned off?

Gents, Does anybody have a recommendation for replacing the small piece of plastic that has been sheared off this small piece of plastic, it is for the roll top box lock on a 124. I want to build up the sheared off part. I am thinking of something like liquid metal as it has to be very...

The plastic screen-washer bottle in my 1998 E200 is broken. The one available from the dealer is not an exact fit. I understand that due to the age of the car and low demand on such item, they are using one that will fit several models. Seals and adjustments are needed to make it work. It will...

They must just break even on these! Honestly - a bit of thick plastic - currently pealing on both sides of my rear pillars (see a few MLs with this now). I reckon a re-lacquer is better a.k.a cheaper - what reckon?

Anyone know if the plastic sheet under the door card is replaceable on the W202, if so any part numbers ? Thanks

Hello All, My W210 has a tan coloured interior. Over the 8 years of it's life it has acquired black scuff marks on the interior plastic, mainly around the door sills from people getting in and out. So far I've tried most of the cleaning products under the sink, Autoglym interior shampoo and...

The plastic panel (skirt?) underneath the 'bumper' on my W211 estate has been damaged and paint has come off in a number of places along a length of about 30cms. Is there a special paint for this that I can use to do the job myself or is it better in the hands of a specialist?

Can any one help?, Im looking to remove the black rear quarter plastic covers from an ML270 (between tailgate and rear glass) as the laquer has started peeling from them. Once removed I was hoping to get them repainted. Any tips on taking them off as they dont appear to be on clips!? thanks.

I'm looking for the little blind grommit poppers that secure the cover to the engine, a couple of mine are a bit worn but they look replaceable. Does anyone out there know the part number? Thankyou.:D

So, one day i have noticed that i have some wet spot were i park my car, and this was like 4liter of liquid spot of 50cm radius. Found this is diesel. My under engine protection cover was full of diesel... if as so scared of fire, i went strait to service, they look, and its not plastic pipes...

Anyone have a spare plastic wheel holder for the above? It's the thing that sits inside the spare wheel holding it down, screws in place but also acts as a support for the boot contents. Thanks,

Hi all, I am after a pair of the triangle black plastic trim pieces on the outside of an A-Class door, a pair as mine have rotted. Its where the little badge sits infront of the door window. Email me if you have some or have seen some in the MK/Bucks area. Thanks.:thumb:

Hello All, It's my very first thread since i bought an ML270 last week, very impressed so far. The lacquer on the rear plastic trim that sits either side on the boot lid window is peeling off and i want to get it re-paint. Does anyone know how to remove these items? Cheers JonnyKeith

I think the old plastic hub caps off the 190e are 15", can some one confirm pls Part no : 124 401 09 24 outside edge to edge is 16.5" inside clip to clip is 15" there the same as item no.25 Êàòàëîã

My bootlip spoiler has just arrived and I need to paint it to match the car. I believe it needs to be prepared with some kind of plastic primer before the top coat. Had a look around and found some on Halfords website, can anybody tell me if this will do the trick or is there something else...