pressure

I didn't like the way my ML55 AMG handled at speed, especially on bendy roads. I visually checked my tyres but couldn't really see any difference. I bought one of those LED tyre pressure gauges and found the front n/s was 26psi and the o/s was 29psi. The rear n/s was 20psi and the o/s was...

Guys, Is it possible to retrofit tyre pressure sensors to w220, it is a 2005 model Mate of mine blown two tyres already, didn't notice nail in time - sensors would come handy would think Thanx

Anyone familiar with this fault ? Low pressure test is fine engine cuts out on high pressure test Pressure sensor test is ok and the valve control tests ok in DAS Various fault codes DAS > 2047-001 Rail pressure to low volume control valve 2015-001 Rail pressure to low volume control valve...

Thinking of getting this pressure washer: http://www.robertdyas.co.uk/P~162451~Karcher-K2-Compact-Home-Pressure-Washer Is the flow rate good enough for a snow foam attachment? 6 l/min, think it was 110bar. The picture on the side showing what it's good for covers bikes and floors, but not...

Hello all, Apologies for the basic question, but can anybody please confirm the correct tyre pressure for a 2006 C220 CDI Coupe. I've only recently purchased it - it has the AMG wheels. Thanks in advance.

Hi everyone, The oil pressure on my 190e 2.6 is concerning me a little. At hot idle the pressure on the gauge is reading a bit under 0.5bar. When the accelerator is pressed, it quickly goes up to around 2, and at 60mph+ it reads just over 2.5. The engine has about 150k under its belt, emits no...

Problem I have is that I have replaced a faulty TPS and valve on on my E55 but for some reason keep getting " tire pressure monitoring reactivate" every time I get back in the car ! I have reactivate and works till car is switched off. My local indi put new TPS bar code into star but still...

I have searched all over for a solution to my problem, but whilst I have found the same problem, no solutions! I have 2002 c220 cdi with a whooshing sound, then drops into limp mode, I have two fault codes P0100 and P1470, I have tried all sorts, checked the cats, not blocked and in great...

http://www.mbclub.co.uk/forums/classifieds-general-sale/151494-free-nilfisk-pressure-washer-hose.html#post1705348

I'm having a clear out and having upgraded the hose on my Nilfisk 140, I have the original which I will otherwise be throwing away. It's used and has the odd split in the outer protective casing but works fine. I just hate the way the plastic hoses don't stay uncoiled. Free for collection...

Good morning all. The car is a '98 E55 AMG. The vendor told me that he had the air-conditioning topped-up to 1000 psi prior to sale because the pressure had dropped to 600 psi, but I doubt (to put it mildly...) those values and it may well just have been dealer bulls**t anyway. I've checked...

MB E class 280CDI 06 Model 50,000miles Car starts and runs perfectly until optimum 80degs running temp is reached. The car then loses power or stalls. With the engine management light on giving codes P0087,2017,2021, 2046, 2047, 2051 most relating "low rail pressure". The diagnostic shows good...

The sticker in the full flap only has pressure for 16" wheels, but I have the 18" 255 35, can anyone confirm the correct tyre pressure please?

MB E class 280CDI 06 Model 50,000miles Car starts and runs perfectly until optimum 80degs running temp is reached. The car then loses power or stalls. With the engine management light on giving codes P0087,2017,2021, 2046, 2047, 2051 most relating "low rail pressure". The diagnostic shows good...

I was wondering if anyone else has had this problem.i have had pump/sender unit replaced on e270 and I am still getting the same reading,any ideas?

As part of my weekly maintenance schedule, I usually check tyre pressures. Today, one the rears was down to 25psi (from the 32psi I normally use). Suspecting a slow puncture I jacked up the car and had a quick look. Sure enough, a screwnail was embedded in the tread. The TPMS hadn't given any...

Hi Guys, Had my car serviced this week, the mechanic noted one front tyre was down to zero tread and the other 3 were about done! So got Event Tyres to come and put 4 new Michelin Pilot Sport 3's on.....at no small cost :crazy: (interestingly he said avoid Conti's!) That was yesterday, today...

I have just had a pressure warning for my rear near side tyre so I stopped at the garage to check the pressure but as I removed he dust cap the valve sheared leaving the top part in he cap. I could get a replacement valve fitted or get Merc to sort the problem out. My only question is where...

Can anyone recommend an oil pressure gauge (mechanical) for my rebuilt 271 engine, as there are no fitted warning indicators, and where to fit the pick up to. I need a constant measure of the oil pressure. The reason is, low oil pressure I believe, caused big end bearing wear and wreaking the...

Does anyone know how this works and at what psi does it trigger a warning? I was wondering if it's better to check with a manual pressure gague on a regular basis rather than rely on the gizmo? Anyone who mentions 600psi will get a lump of coal from santa this year ;)