remove

Can someone please advise me on how to remove the rear boot cover in front of the spare wheel. I can take the cover from the boot exposing spare wheel etc, but would like to know how to remove cover in front of this to change the yaw/latereral acceleration sensor. Many thanks Mark

have a w202 c36 and the back three windows are tinted aftermarket how to remove the best way i fear that if i try to remove from back window i will damage rear heating element any ideas:confused:

Guys, I need some help today. I need to pull the overhead panel down. I got the rain sensor cover off, mirror base cover from overhead control panel control unit as well. Now comes the part where I'm stuck: The mirror itself. WIS says How hard do I have to pull down and do I have to turn...

hi all, how can i remove the cover on my wing mirror please to gain access to the plug to reset the mirror?? any help please as at the moment it is booked in thursday at a garage, and dont want to pay out if it is something i can do myslef. many thanks James

hi guys, wondering if any1 could help me remove the cover of my wing mirror to get to the "loose" wire that is resulting to the dash showing the indicator bulb to be faulty, (but is not) many thanks again, James

Hi guys, I have only had my merc a month, Its a 2006 C220 CDI 4 door sport edition which has covered only 25k I am replacing a few interior trims as they have some scratches (I am a bit picky). The wheel which is star shaped on the drivers seat on mine is scratched and I have ordered...

Hi, found this forum which looks great after a bit of googling, hopefully someone will be able to help with an issue I have. I am in the process of cleaning my car inside and out thoroughly but have hit a snag. On my centre console at the sides, Denim dye stains have rubbed off from jeans...

Hello to everyone out there I am new to this forum, I have recently got a CLK320, and have a couple of things to sort out, I have had the rust patches on the arches done, now I want to remove the phone cradle that was factory fitted, as I wont use it. It is fixed behind the panel that houses the...

I am trying to remove the glovebox on our CLK and have managed to find most of the fixings but not sure how to locate the fixings nearest the centre console Can anyone offer any advice Thanks Mike

the carbon looking trims on the sides of the doors of a S210. Mine are looking discoloured and corrosion starting to show in areas. Also, how much can I expect to pay for a set? Thanks

After months of scouring Ebay a set of right hand side steering wheel control (i.e. volume buttons...) finally came up. Duly bought and arrived today. Looking at these they are held by screws beneath the airbag cover. Any clues as to how to get this off without setting it off would be...

Hello. Its a W168 model automatic transmission. I want to remove the automatic trans floorshift but I have no idea how to remove the center console especially the hand brake part. Anyone have a guide that can guide me on how to remove the complete auto trans floor shift ?

Hi. Does anyone have a good guide on how to remove the W168 Auto transmission ? Picture included would be much appreciate :bannana: Thanks in advance.:rock:

I went thru all possible threads about EGR on 320CDI and I cant find any info as how long does it take to remove it and clean it. I would like to know if I need any other parts/gaskets to do it properly. Do you think I can have some problems doing job of cleaning EGR? I need to check it as my...

I am trying to remove the rear seat cushion on a 1999 SL500. I have pushed and pulled the red tab and lifted and pushed the seat but it will not move. Any tips would be appreciated!

Hello, MY 2004 W211 E270 CDI. Found a leak into the spare area in the boot/trunk and the source is the creased joint marked in the pic below. I tried to remove this panel but was unable to do so as I feared I may snap something (it seems to be made of plastic fibre). Meanwhile I have as a...

I have been researching into this and even see there is a video of it on Youtube, making it look easy. However, I cannot get the cylinder to pop out. I have tried various sizes of allun keys and pins etc. They say it should be a 1.25mm wire. Does it have to be exactly this width? I am in...

I have a 1995 E280 estate and want to replace its pre-facelift rear bumper which I put following accident damage years ago as a temporary measure. I now acquired the original colour coded bumper from a cannibalised W124 estate. I removed the 8 nuts (4 on each side) found under trims/spare...

Can anyone give me the procedure for removing side repearters on my 95 R129 please?

I'm pretty sure my S211 has electrically adjustable front hear restraints. If so how can I get them off? (I want to fit some DVD ones). My C43's both had leccie ones and I could never figure out how to remove them. (I don't car if I lose the leccie adjustment - one of the less useful...