rollbar

Looks like I have a creaking torsion bar bush on the off side front of my W221 I have purchased some epoxy resin to glue the bush to the mount in order to stop the dreadful noise it makes when going over undulations in the road

Hi all. I need to remove the rear pop up roll bars from my 03 w209 cab. Seats are out and looking at a sea of metal and hex nuts...not sure how to proceed with caution. Anyone have a copy of the relevant WIS page(s)....or some sagely advice. I am fairly sure this must be a rare DIY job...

Not sure if this is the right section to post this but on two occasions recently the rollbar in my SL600 (R129) has deployed, once when going around a right hand turn and once over some bumps. Would I be correct in assuming this could be down to a faulty sensor somewhere?:confused:

Last few times I put the roof down, it initially didn't work, but after moving the rollbar up then down again, the roof decided it would go down after all. Tonight, the roof wouldnt open, so I put the rollbar up as before, but the rollbar made a strange clicking noise as I put it up. The...

My R129 only just started for the trip to the GTG this morning ... battery was a bit low. The roof switch is now permanently illuminated and both red LEDs are permanently showing on the rollbar switch. Neither operate, but there's no rollbar fault light on the dash display. The car has the...