seal

Hi. Might be a long shot however here goes: Reference W210 Saloon 2001 E320CDI. Has anyone any knowledge of a Mercedes Recall or any type of request for agents to check or changeout the rubber seal surrounding the bootlid lock? I'm told that the seal was redesigned either in late 2001 or...

I get an annoying wind noise from the drivers door. It goes away when I push gently on the window. Any easy fixes? Thanks

Hello everyone I have a 280 sport v6 and recently my turbo was destroyed. The pipe that connects onto the turbo from the two airfilters has a small orange sleeve so it fits snug. This sleeve broke up and went through my turbo. It's £28.00 from Merc but alot cheaper than a new turbo and...

hi im looking to treat some rust under the car i have a little but im looking for some thing that you treat the rust first and then seal with some under seal any tips would be great thx

Hi all I wonder if anyone can help with this problem. I noticed the other day that the soft top wasn't sealing properly to the rear deck on one side. Normally I'd expect the rear of the hood to seal by the rear pins being pulled down, tensioning the soft top against the bodywork. The...

anyone have an idea of whats involved on replacing the outer rubber seal, under the metal beading, on the rear cabrio window? any advice appreciated! if im gonna ensure this leak never happens again, i might aswell address the external seal, incase it has been compromised in any way!!

Hi, It's getting colder and I'm looking to improve the sealing on my standard up and over garage door. Has anyone an effective and inexpensive idea of how to improve the draft proofing? Thanks Toby

I have been investigating the source of wind noise after a longish journey with the hood up recently. The folding mechanism sits on a rubber seal above the bodywork, but both metal and rubber end about nine inches behind the doors. This leaves a gap between mohair and metal through which you...

Hi to all,I've been searching and phoning but can't find this seal anywhere .Found a good rad site they answered the phone as well.Rad diagrams Car Radiators for less, Ford radiators, Honda car radiator replacement, Toyota radiators,Vauxhall, Bmw Radiators. I am not sure if it is my lack of...

I am about to attempt and renew my injector seal on one of my injectors. Now I know I need a new bolt, seal, special grease and the tool for cleaning the seat which I assume I can get from the dealers. Can one of the many experts on here tell me what else I may need and any problems I may...

My injector seal is starting to leak again. Now I have 1000 mile round trip to make for a week. 400 miles there and 400 miles back a week later. Is this advisable and what is the worst that I can expect. Many thanks in advance:wallbash:

Good morning, I've just noticed a big rip on the rubber seal running all around the hatchback on my 07 C220 cdi coupe. Can somebody ensure I have the right PN (I think I found on euromerc Product ID : A2037400678 ) & also is this an easy job or one to send to my local to do. (I have trouble...

Hi, at the bottom of the the windscreen on the 2002 w210 where the glass meets the seal ,the seal about 10mm wide (or it seems like 1 seal each side ) which integrates into the black plastic panel has gone cracked and disintegrating . The seals taper to a curve so look like they are a premoulded...

My SL roof has seen some action this week and I noticed some noises. I checked out a thread about fixing a noisy SL roof, the advice being to buy some lubricant (part number A000 989 36 60) from MB so I trotted of to the local Main dealer. The lubricant titled Spezial-Gleitmittel, Fluid...

Hi noticed my rear diff is leaking from the right side seal, Ordered a new seal, Are they easy to change, Anything a need to know before i pull it apart, Im guessing its a case of unbolting the drive shaft and popping the shaft out? thanks

I'm planing on giving the cars interior a good clean this weekend . Its a Grey leather interior , and the car is a 211 . I have noticed that material covered door seals have gotten very dirty along the lower areas where shoes have rubbed against them . I was thinking of the best way to clean...

Have a small drip from possibly the front crankshaft oil seal, looked up other posts and have acquired some seal conditioner. Can I throw this in with the exisisting oil (3000 miles since last change) or do I have to use fresh oil and a new filter? Will do the change, but really do not want to...

The oil seal on my 1998 (36,000 mile) R170 recently failed, flinging a mist of oil from the electromechanical clutch. Enquiries to my local main M-B dealer revealed that a replacement oil seal was not available and that a new blower would cost me £1850 plus fitting - say £2000-ish, all in...

Has anyone needed to replace the rubber section that fits into the upright guttering of the o/s rear window ? The bit thats the seals front and back windows when closed. Mines currently held on with 'glue' as its split and out of the guttering at the lower section so sometimes gets caught...

Can anyone suggest a good sealant type adhesive to fit a new boot seal with on my W126 please? Obviously not bathroom type silicone as that rusts metal. I'm getting exhaust fumes in the car and this is something i thought worth doing anyway as it also leaks slightly.