Help guys, i haven't seen an S320 in the scrappies and have looked elsewhere for the power connector and a bit of wiring for my CD changer. It's a 3pin connector which has been removed from the wiring on my car. I'm left with the wires and hope to get a bit of wiring with the plug so I can...
2007 W164 FM aerial questions
I am trying to fully understand the diversity aerial set up and booster arrangement on this model and need some help from anyone that has been here before.
At the head unit end, my car has three Fakra connectors. Bright yellow, black and blue.
Blue is for...
We've left the car parked for several months at my uncles warehouse...
I wish I was joking but a bloody mouse has munched through the wiring to the brake booster's sender right at the multi plug....
...And the furry little sod has nicked about 6 inches of loom
So I've got several bare wires...
Originally it started off that the bass speaker in the passenger door would cut in and out and it was suspected it was the voice coil in the speaker. I replaced the bass speaker with a brand new Audison one but it was still cutting out. Then it was far more out than in and then mid speaker above...
Hi,
Has anyone got any idea where and how I hardwire a dash cam in my e320 ?
I'm fed up with having to use the 12v socket in the front of the car and wires trailing all over the place.
I've seen somewhere a piggy back wire that plugs into the fuse box, can anyone help please ?
I have just bought a Thinkware F750 2CH dashcam (Hard-wire version) the only wiring diagram they have supplied is a basic 'stick it to your windscreen and plug it into the cigarette socket' (And I don't have the cigerette plug).
The loom has one obvious earth, one yellow and one red wire each...
I have just bought a Thinkware F750 2CH dashcam (Hard-wire version) the only wiring diagram they have supplied is a basic 'stick it to your windscreen and plug it into the cigarette socket' (And I don't have the cigerette plug).
The loom has one obvious earth, one yellow and one red wire each...
Hi, I have a 2012 W639 Vito which has poor radio signal. Was advised that it was generally poor from the in screen antenna and the best solution was to install a roof nounted aerial. I have done this, but now have to attach the power wire from the aerial for amplification somewhere. I think...
Help and advice would be very much appreciated.
Having some automatic transmission issue causing the car to go Limp mode. Car would drive but 30min into drive and the gear indicator and driving mode (P,N,R, D & C,S,M) in dash would disappear and reappear intermittently but would end up...
W210 mirror wires are many and varied. Fitting them to the W202 door is something of a trial if you don't know the conversion.
Here it is:
function ................Folding W202......................Folding W210 facelift.
heater....................... ....1...
Hi all I've owned my 2008 2.1 e220 auto for 5 weeks now & in random times it's went into limp mode, put the engine check light on, ran rough on idle or rough just plodding around. These happened some together, some not & at total random times. The garage are getting it sorted under warranty but...
Can anyone on here let me have a copy of a wiring diagram for a drivers side door mirror, with power fold, for a 2005 CLK Convertible.
Many thanks.
Steve
Hi All I have cloth seats fitted to my clk convertible and have aquired a full set of interior in black leather that are in very good condition indeed, as my original interior has electric seats being cloth it only has the one or two control switch on the door panels the new interior has 1,2,3,4...
Hi guys,
Does anyone know any recommended audio shops that are located in London that can do audio rewiring?
My rear speakers seem to be dead and seeing that the car is from 1992, I'm sure some wires have deteriorated somewhere down the line, so looking to get them reworked and rewired...
my ML recently blew it's trans (needle roller collapsed in the trans) so i fitted another. Prior to this the handheld scanner I have (carsoft) readout the code as P2502 . it still does despite me trying to erase it.
What do Mercedes suggest could also be at fault with this code beside...
Just bought 2006 ML350 about a month ago. Really unhappy with the dipped beams, and I've also had a dipped beam warning from day one, although the light is working.
The dips are halogen, but when I remove the bulb holder I found that the yellow wire had been removed completely and was just a...
Hi - I recently bought a replacement drivers side wing mirror, as the OEM Merc mirror had become "foggy". The OEM Merc mirror has 4 wires going into it, the new mirror has 2 x tags for soldering.
Photos attached - OEM has plug and wires, new mirror has only tags for soldering wires onto...
Hi, im going to check the wiring harness for signs of damage tomorrow, does anyone know of any weak points? Or should i completly remove the harness to check it over?
My ml is in limp mode and showing 0 resistance between pin 15 and 38 on the etc plugs.
Thanks
I just replaced my loom for a new genuine MB item as part of a long-term restoration project that I'm doing on my cabriolet.
Selling my old loom to anybody who wants a cheap/quick fix to get them out of a pickle on their car.
The loom is showing signs of being quite tired and has the usual...