Lee1092
Active Member
The cable snapped on my window so i've replaced it, however now the window doesn't seal when its shut.
At first the window hit my b pillar so we loosened the clamps that hold the glass in place and slid the window over a bit and it now clears the b. Pillar and we thought we had it sorted but when I drove it home from my mates garage I noticed a bit of wind noise. When I've looked closer its not sealed at the bottom left hand side of the glass, as if the glass is too proud.
Has anyone encountered this before and does anyone know how it can be sorted. I only done half the job so not sure if its something to do with the mounting of the full mechanism, is there some sort of adjustment on that or is it just a fiddly job to keep moving the glass about?
At first the window hit my b pillar so we loosened the clamps that hold the glass in place and slid the window over a bit and it now clears the b. Pillar and we thought we had it sorted but when I drove it home from my mates garage I noticed a bit of wind noise. When I've looked closer its not sealed at the bottom left hand side of the glass, as if the glass is too proud.
Has anyone encountered this before and does anyone know how it can be sorted. I only done half the job so not sure if its something to do with the mounting of the full mechanism, is there some sort of adjustment on that or is it just a fiddly job to keep moving the glass about?
