ABS and Display fault and brake wear

Discussion in 'Electronics' started by cmoore2889, May 7, 2017.

  1. cmoore2889

    cmoore2889 New Member

    Messages:
    1
    Joined:
    Apr 26, 2017
    Car:
    clk 270
    Hi, I’m new to club but would like some guidance from you wise people out there. I have a CLK270 registered in 2005. Trying to keep it going on a budget. Sometimes, upon stating, the ABS light stays on, then a "display faulty" is shown followed by "brake wear visit workshop" the ABS warning does go off after about a minute, the engine management light then comes on but eventually goes off after a few starts. Would be grateful of any advice. Cheers Chas..
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.