ABS diagnosis error on my mercedes E220 petrol w124 chasis.

[rushikesh]

I have an 16 pin diagnosis connector. where do I pin my scanner to check for ABS system ?
Is there any other port excluding the 16 pin connector for ABS diagnosis ?
I have actually pinned my scanner pin in all ports for checking but no luck found for abs diagnosis
Thank you in advance

 

[tjamesbo]

What is the problem with the ABS ? I would check the sensor wiring first IIRC i think you check resistance I had ABS problem on my W124 320TE it was chirping at low speed and then the light was permanently on Checked the sensors RHS was faulty replaced and all good now Not much info around on interrogating fault codes on these cars a lot use a homemade blink tester and the flash codes can be looked up
Good Luck & Keep us posted with the outcome
Boyd

 

[grober]

PIN 5 will give wheel/diff sensor readouts
see the sections on ASD/4MATIC here

http://www.diakom.ru/CARS2/pribor/cs1000/manual/cs1000_mb.pdf

there is no ABS readout port on the 16 port connector only the 36 round one