• The Forums are now open to new registrations, adverts are also being de-tuned.

ABS/EPS Warnings on display since Brake Rebuild

Boffin486

Active Member
Joined
Jul 31, 2021
Messages
72
Location
Aberdeen
Car
W203 CL220 Sports Coupe SE, C280 Avantgarde SE & Also Audi A4 B7 Avant Quattro & 3 Calibras
Hi folks - I have completely rebuilt the braking system on my Coupe but since the MOT (it came on during the Test) the ABS/EPS warning is on the display.

See previous thread : Full Brake Rebuild & Upgrade | Wheels, Tyres, Brakes & Suspension

I have actually replaced everything - all 4 Calipers & Disks as well as the ABS sensors all round but the warning persists. What am I missing? does the warning actually mean anything or does it just need to be reset? The car is due MOT again so I need to fix this pronto. Is there a procedure to be followed with the ABS pump/distributor (ie cycle all the valves electronically & bleed the system)?

Any thoughts folks?
 
Replaced all 'ABS' sensors. ? Not shown in your first thread. What ABS sensors did you replace ?
All 4 of the sensors in the hubs front and back.
 
Get the codes read , at least it will point you to the correct corner for further investigation.

K
 
some DTF need a code clearing after replacing failed component. Others self clear.
Clear codes, lock to lock, small drive.
See if fault comes backS
 
Ta for that, I'll borrow a code reader & see if I can get a fault code but I think Generic code readers cannot access ABS readings.
 

Users who are viewing this thread

Back
Top Bottom