Blasting + Powder coating facility

Screwdriver

Active Member
Joined
Oct 20, 2008
Messages
355
Greetings!

My W115's lower arms/ rear wishbone setup is in needed of surface rust removal via bead/ sand blasting followed by a powder coat job that will last another few decades. Ideally, they'd be able to work on it without the need for removing the rear hubs/ bearings. See example of my other car, a W123 with this job done.

Wanted to ask if anyone had used such a facility with any success?

Many thanks!
Underchassis Final.JPG
 

Doodle

MB Enthusiast
Joined
May 3, 2005
Messages
5,177
Location
Echo Beach
Car
R129, Leon Cupra 290, BMW R100
Ideally, they'd be able to work on it without the need for removing the rear hubs/ bearings.
While unfamiliar with the minutae of 115 suspension, I'm not sure how that could happen without compromising the job? Blast material in the hubs/bearings, plus subjecting them to the bake temperature would be major concerns.
 

Users Who Are Viewing This Thread (Users: 0, Guests: 1)

Top Bottom