Blasting + Powder coating facility

Page may contain affiliate links. Please see terms for details.

Screwdriver

Active Member
Joined
Oct 20, 2008
Messages
420
Greetings!

My W115's lower arms/ rear wishbone setup is in needed of surface rust removal via bead/ sand blasting followed by a powder coat job that will last another few decades. Ideally, they'd be able to work on it without the need for removing the rear hubs/ bearings. See example of my other car, a W123 with this job done.

Wanted to ask if anyone had used such a facility with any success?

Many thanks!
Underchassis Final.JPG
 
Ideally, they'd be able to work on it without the need for removing the rear hubs/ bearings.

While unfamiliar with the minutae of 115 suspension, I'm not sure how that could happen without compromising the job? Blast material in the hubs/bearings, plus subjecting them to the bake temperature would be major concerns.
 

Users who are viewing this thread

Back
Top Bottom