Hi
I recently had a new rear SAM unit fitted due to water getting onto it.
Eventually found it was from joins as shown in pics.
The question is does anyone know how to stop these from the source? If I just seal these points inside then somewhere, perhaps a box section? could always be full of water!
pics..
https://lh3.googleusercontent.com/P...qGkBhRiGz4ovn4kFfgmSwrQLCn44vpM=w1143-h643-no
thanks
I recently had a new rear SAM unit fitted due to water getting onto it.
Eventually found it was from joins as shown in pics.
The question is does anyone know how to stop these from the source? If I just seal these points inside then somewhere, perhaps a box section? could always be full of water!
pics..
https://lh3.googleusercontent.com/P...qGkBhRiGz4ovn4kFfgmSwrQLCn44vpM=w1143-h643-no
thanks