Comand - APS navigation drive connections

[Paul Grainger]

Hi
Does anyone know the part number for the power connector plug to the remote navigation processor used on an SLK Comand-APS. It will be the same as all 'similar' comand APS systems.
Alternatively, can anyone provide connection details to the nav unit? I can only presume that there will be +12v, Ground and a wake-up line connection, but I haven't got a clue which pins they go to on the nav processor unit.
The MOST and antenna connections are easy (I bought a loom, but it didn't include the actual power connector)
Thanks in anticipation of an answer!
Paul G

 

[Diesel Benz]

I believe pin 2 is power, pin 1 is ground and pin 5 is wake-up.

I did not try to find the connector part number.

 

[Paul Grainger]

Thanks - but the pins aren't numbered - do you know which pin 1 is?
The part number for the connector - if you could find it - would really be very helpful!

Paul

 

[Diesel Benz]

I believe the connector housing part number is A0465450828, contacts springs A0135451526.

 

[Paul Grainger]

DB - Thanks for your help.

The nav is now working perfectly. My next problem is how to re-instate the CAN connections to the AGW.
I removed an ICANI phone interface which had been 'botched in' (quite literally) to the CAN connections at the AGW. Before I removed this interface, the steering wheel controls etc worked fine. Now they don't, and I have a number of wires - some of which are obviously the CAN connections - to reinstate. Unfortunately, it doesn't seem to be colour-to-colour as the wiring has been altered when the ICANI interface was fitted.
Please can someone (hopefully you, DB!) provide connection info for the AGW. The only connection info that I need is for the one including the MOST bus and CAN connections, including the original wire colours.
Thanks again, DB, for your help on this one.

Paul G