jpskiller
Active Member
note not a MB, but a Jeep
Few months ago I replaced the backbox and cat for new ones (ebay), the cat is the type where the pipes slide into it and has A clamp on each end.
Have noticed recently that where the front pipe and cat join, it is blowing quite a bit from round the top of the join area, and a little from the other side of the cat(expected I guess from the amount blowin at front) as well.
Tried tightening Clamps, but don't want to go to far and break them
Whats best / quickest way to resolve, ie more clamps, cut pipe at 12,6,3,9 if so how deep.
help pls
Few months ago I replaced the backbox and cat for new ones (ebay), the cat is the type where the pipes slide into it and has A clamp on each end.
Have noticed recently that where the front pipe and cat join, it is blowing quite a bit from round the top of the join area, and a little from the other side of the cat(expected I guess from the amount blowin at front) as well.
Tried tightening Clamps, but don't want to go to far and break them
Whats best / quickest way to resolve, ie more clamps, cut pipe at 12,6,3,9 if so how deep.
help pls