fitting moulded trim to front bumper C180 elegance 2002

Discussion in 'Bodywork' started by tonygima, Jun 10, 2010.

  1. tonygima

    tonygima New Member

    Messages:
    24
    Joined:
    Jun 10, 2010
    Hi, I have just acquired my father's C180 Elegance, 2002 model. The front bumper moulding (with chrome strip attached) is badly damaged and needs replacing. I have ordered a replacement part; is there any difficulty in fitting this please, or any potential fitting problems I should now about?

    Thanks in anticipation

    Tony
     
  2. nick mercedes

    nick mercedes MB Enthusiast

    Messages:
    7,107
    Joined:
    Jan 8, 2003
    Location:
    far far away
    Car:
    Ford Expedition
    They just clip on, when you get the new one, you'll see from it where the clips are and which direction to pull the old one off (fnar fnar).
     
  3. OP
    OP
    tonygima

    tonygima New Member

    Messages:
    24
    Joined:
    Jun 10, 2010
    Thanks Nick.

    I forgot to mention it's the offside moulding that is being replaced. The diagram shows a square recess (which is covered by a square piece of plastic trim on the vehicle). Forgive my ignorance but what is 'fnar'?

    Regards Tony
     
  4. nick mercedes

    nick mercedes MB Enthusiast

    Messages:
    7,107
    Joined:
    Jan 8, 2003
    Location:
    far far away
    Car:
    Ford Expedition
  5. OP
    OP
    tonygima

    tonygima New Member

    Messages:
    24
    Joined:
    Jun 10, 2010
    I like the association with cunnilingus!!

    :eek:
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.