How remove the rear bumper centre strip w203?

Discussion in 'Electronics' started by sobeus, Aug 21, 2008.

  1. sobeus

    sobeus Active Member

    Messages:
    60
    Joined:
    Jul 6, 2008
    Location:
    Sweden
    Car:
    W203 C180K Sport Edition 2006
    Hello folks

    I am about to retrofit parkingsensors on my W203 5 doors. I just wanted to check if someone know how to get the center strip of the rear bumber of. If anyone has done the retrofitting to there W203 5 doors cars please if you could do a bit of explanation to me. I see that one person has done this to there W203 4 doors. But i dont know if its comaprible to the 5 door`s?

    Best Regards

    Jesper
     
  2. gazz

    gazz Hardcore MB Enthusiast

    Messages:
    435
    Joined:
    Mar 9, 2006
    It is just a push fit into the bumper, but it is hard to remove. I use some plastic wedge tools that I bought from Snap-On. I find it easiest to start on the bottom edge, near the point that it starts to go round the corner... Good luck!!
     
  3. R2D2

    R2D2 MB Club Veteran

    Messages:
    6,935
    Joined:
    Mar 23, 2004
    Car:
    C350
    Undo the the screw in the edge of the wheel arch and take the side trim off first then getting the centre one out is easy.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.