Ignition control modul...help!

Discussion in 'Engine' started by Stringer, Sep 24, 2012.

  1. Stringer

    Stringer Hardcore MB Enthusiast

    Messages:
    144
    Joined:
    Sep 16, 2012
    Location:
    Lebanon
    Car:
    300E 1987
    Does anyone know how to check one of these with a simple multimeter? I think mine is over-heating due to the heatsink behind it drying out - but before i roll my sleeves up and pull it off, i wondered if anyone knew the ohm readings?

    Also, is there a paste which i could buy in a hardware store which would work just as well for the thermal gel?

    thanks again
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.