• The Forums are now open to new registrations, adverts are also being de-tuned.

Parktronic loom

Druk

Gone but not forgotten - RIP
Joined
May 28, 2004
Messages
5,300
Location
Not far from Edinburgh.
Car
2011 S212 E350CDi. 1981 R107 300TurboDiesel.
Anybody got an old loom spare who could send me one of the orange oval lip seals. I have replaced two of the rear sensors but one of my O rings is torn and they dont come separately. For a W211 but other may be similar.

Thanks.
 
Tnxs. I've got a simple O ring kit in t'garage. These are double lip silicone rubber and an oval planform.

Not the best of pics but lying under car in drive.....hey-ho.

Oring.jpg
 
Last edited:
Parktronic fault

Druk,

How did you get on with your seal problem?

My 2004 W211 shows a parktronic fault after washing or driving in the rain. I believe it may be in the front offside area. Can anybody tell me if one can easily remove/unclip the piece of trim holding the sensors?

Regards,

John
 
Last edited:
John.

My problem was with the rears. Easy to get at. I sealed the plug with silicon. I think you will do cosmetic damage by trying to lever off the front bumper infills. The complete bumper is actually not that difficult to remove in one piece. The front undertray and wheelarch liners hve to come off and that's probably the hardest bit of the job. After that there are only about half a dozen easy screws and a clip or two.
 

Users who are viewing this thread

Back
Top Bottom