Stumpy1981
New Member
Hi Everyone,
Need some advice regarding my 2005 CLS320 CDI, yesterday it went into limp mode. Had the codes read with a OBDII Snap-On scanner. The codes are as follows;
Any advise will be appreciated.
Cheers
Need some advice regarding my 2005 CLS320 CDI, yesterday it went into limp mode. Had the codes read with a OBDII Snap-On scanner. The codes are as follows;
- 2078 - Check component B28/8 (Pressure differential sensor (DPF) ). The signal voltage is too low.
- 2355 - Check system Exhaust gas recirculation control. The air mass is too large.
- 2030 - Check component G3/2 (O2 sensor upstream of KAT). Signal wire open circuit.
- 2038 - Check component G3/2 (O2 sensor upstream of KAT). Resistance too small.
- 2195 - Heating Check component G3/2 (O2 sensor upstream of KAT). Signal wire open circuit.
Any advise will be appreciated.
Cheers