Remapped or not

Page may contain affiliate links. Please see terms for details.

possle

New Member
Joined
May 15, 2022
Messages
3
Location
Nottingham
Car
C350 cdi
My Car is due for a remap a week Monday
As for as I know the car is standard but I've also thought it went quite well for what it is.
Didn't chat with the dyno guys and I simply went for a run.

I've also recorded a 0-60 time of 5.2 seconds which some YouTube research shows times are similar to mapped cars, either that or its quicker because I'm not banging the redline

Any opinions, thoughts, insights please
Bhp up 11 ish (different dynos and all that)
But torque is up at 680NM, i believe mapped 350's are close to 700

20220604_093709.jpg
 
What year is it?

Are those figures estimated crank, or to the wheels?

Assuming estimated crank, I'd guess mildly mapped (aka generic), especially if you're really doing 5.2. That's a full second faster than quoted for a 265BHP E350. Edit: sorry, just saw C350, a bit lighter than an E350, so I'm not sure of the quoted times for that.

An MSL or GAD tune will get you to over 300bhp and well over 700nm, though. If your graphs are measured at the wheel then you have very healthy remap figures!

I have not seen confirmed 0-60 runs on those.
 
Last edited:
Its a 2011 model so 265bhp as standard. Wheel power is on that sheet.
235-238 bhp

The 0-60 was on a generic App unsure of accuracy, that's all I have
Don't have a draggy to test.

Generic seems about right as it's definitely up on torque but quite a bit.
The celtic tuning website (use for a guide) shows 515ft lb after a map. This shows it about there already.
 
Last edited:
Perhaps it's already been remapped, they would probably see that when they plug it in.
 
I’ll say remapped already, reading slightly lower figures on an honest dyno.
 
Looks like its mapped to me, shouldn't they be about 420lb/ft torque?
 
Looks like its mapped to me, shouldn't they be about 420lb/ft torque?
That's what I thought. But I don't see where that jump in torque has come from.
About 11bho increase but that amount of torque doesn't make sense to me.

I'm going to ring them Monday and see what they say
 

Users who are viewing this thread

Back
Top Bottom