John Sessions
New Member
- Joined
- Oct 2, 2013
- Messages
- 18
- Car
- Merc
Following a slight mishap, I've re-fitted the rear bumper to my S210 320 CDI Estate.
Surprisingly, I found some co-axial cable hanging out of the black vent panel below the NSR window when I removed it, which had obviously been ripped from some connector. It's about the right length to reach the bottom of the window behind the spare wheel area.
The aerial is in the NSR window. At the top, it's connected to the booster gubbins behind the removable square panel in the roof at the top of the window. So far so good.
But - I can't find where it's all supposed to be joined up. Does anyone know the route of the wiring from the top of the window down into the loadspace? I'm trying to avoid taking all the trim out the roof if I can help it!
Cheers!
Surprisingly, I found some co-axial cable hanging out of the black vent panel below the NSR window when I removed it, which had obviously been ripped from some connector. It's about the right length to reach the bottom of the window behind the spare wheel area.
The aerial is in the NSR window. At the top, it's connected to the booster gubbins behind the removable square panel in the roof at the top of the window. So far so good.
But - I can't find where it's all supposed to be joined up. Does anyone know the route of the wiring from the top of the window down into the loadspace? I'm trying to avoid taking all the trim out the roof if I can help it!
Cheers!
