had a VHC done at MB today and their video showed uneven tyre wear front and back.
Both fronts were wearing on the inside and outside section, by 3mm compared to the middle. They are pirelli p zero's 245/35/19's with 38psi
The rears are 1.5mm less on the inside edge compared with the middle and outer, with 40 psi, 275/30/19 uniroyal R3's. Middle is 6mm
I had a 4 wheel alignment done when the rears were fitted around 5k ago, at WIM with just a couple of minor adjustments.
I was told the rears tend to wear faster on the inside due to the setup, but I am quite suprised with the wear on the front.
Apart from another alignment, is there anything i should be checking?
Thanks
Both fronts were wearing on the inside and outside section, by 3mm compared to the middle. They are pirelli p zero's 245/35/19's with 38psi
The rears are 1.5mm less on the inside edge compared with the middle and outer, with 40 psi, 275/30/19 uniroyal R3's. Middle is 6mm
I had a 4 wheel alignment done when the rears were fitted around 5k ago, at WIM with just a couple of minor adjustments.
I was told the rears tend to wear faster on the inside due to the setup, but I am quite suprised with the wear on the front.
Apart from another alignment, is there anything i should be checking?
Thanks