W124 606 Vacuum and Engine Wiring

Discussion in 'Engine' started by Ed124, Mar 30, 2014.

  1. Ed124

    Ed124 New Member

    Mar 30, 2014
    W124 606

    I've recently acquired a W124 with a 606NA which I'm loving!

    I've already sorted a few little issues but yesterday I tackled changing the glow plugs, thankfully they came out no problem. It's not back together yet as I need to get the glow plugs and some of the crank breather hose connections need replacing, arriving Wednesday hopefully.

    However, someone had been there before me and messed with the electrical connections to the vacuum valves attached to the underside of the inlet manifold. The insulation had crumbled.

    I've repaired these with some self amalgamating tape and heat shrink tube and re soldering but I'm not too sure about which wire goes where now. I'm not convinced any of the butterfly valves were working.

    Would anyone have a schematic, or photo of the the valves and the vacuum lines please?


Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.