stuartbowes
New Member
- Joined
- May 7, 2011
- Messages
- 3
- Car
- CLK 220 CDI SPORT
Dear Experts! I've just installed the A164826000764 wiring kit to stop the electricity 'arcing' problem on my Rear Left Light Cluster. I'd successfully installed the same kit a good few years ago on my Rear Right Light Cluster. The car is a 2010 ML 300 CDi Sport. I bought the kit from Ebay and it was a genuine Mercedes Benz part. There was no instructions with the part, but I followed a YouTube video. After installation I now have the following error messages on the dash which were not present before installation:
TURN SIGNAL, REAR LEFT
REVERSING LAMP, LEFT
LEFT-HAND TAIL LAMP/REAR FOGLAMP
LEFT-HAND TAIL LAMP
The video stated I needed to remove the 'pink' wire from the block connector and place it in the middle slot on the new wiring loom. I then placed the new bulb holder in the very top position of the light cluster and connected the green earth to the bodywork. I can only imagine the pink wire is not the correct one!
Any help would be greatly appreciated!
TURN SIGNAL, REAR LEFT
REVERSING LAMP, LEFT
LEFT-HAND TAIL LAMP/REAR FOGLAMP
LEFT-HAND TAIL LAMP
The video stated I needed to remove the 'pink' wire from the block connector and place it in the middle slot on the new wiring loom. I then placed the new bulb holder in the very top position of the light cluster and connected the green earth to the bodywork. I can only imagine the pink wire is not the correct one!
Any help would be greatly appreciated!