W210 comand problem

Page may contain affiliate links. Please see terms for details.

amg3.6

Active Member
Joined
Jun 25, 2009
Messages
921
Location
UK
Car
C55 Amg White W202
The gps works as the maps come up. When a destination is entered it calculates the route shoes arrows and milage but doesn't show or do anything else no instructions any one know whats going on?
 
Firstly apologies if this sounds daft-but does it have a reset button(factory restore setting)-just thinking like a computer sometimes needs a hard reset to restore?
 
I dont think there is a factory reset. Could i have missed anything as i retroed the comand in my c43. Could it be the speed signal wire i am pretty sure its all ready there
 
the gps works as it picks 5-6 satallites. First it wasnt picking any now thats sorted the problem now is when a destination is entered it calculates the route once that's done the directions don't move any one know whats causing this?
 
Its canbus
 
Iv'e tried that what if the speed pulse isnt connected? How do i check if i have one? I have checked through the service diagnostic mode it shows shows 5 satallites but where it shows the speed pulse shows 0 mph
 
here is a pic
 

Attachments

  • IMG_0889.jpg
    IMG_0889.jpg
    227.5 KB · Views: 23
It is going to say 0 unless the car is in motion anyway. Have you checked if it still says 0 whilst driving.
 
Have checked it whilst on move stays on 0mph
 

Users who are viewing this thread

Back
Top Bottom