W211 license bulb replacement help!!!

Page may contain affiliate links. Please see terms for details.

ivan1996teo

New Member
Joined
Aug 7, 2014
Messages
23
Location
Malaysia
Car
w211 2003 E270 CDI
Hi all,

I yesterday had installed an error free led bulb to replace my W211 original license bulb. After i install it, the led still couldn't work, the speedometer shows error too.

So what should i do to solve this problem, hope guys can help me. Thanks a lot.

Ivan here.
 
was it working before you replaced the bulb?

1. swap it with the working one - if this works then its the bulb itself.
2. if it doesn't work - then you have a cut in the wiring near the hinge (common), remove inner panelling and you will see the wiring - the cut will be pretty obvious.

good luck
 
Yes, its working before i replace the bulb.

I mean i wan to change to LED light (white). Becuz the original one is too dim and its orange light.

Thanks for reply.
 
Did you connect it up the wrong way around? They're polarity sensitive.
 
No, I had tried plenty of times
 
Might be the LED bulb, it will be cheap out there in Malaysia... Try another LED bulb.
 
will be the bulb in that case, try the normal bulb back in if that works its defo the bulb.

I have the LED light packs in mine

IMG_0392.jpg
 
Looks stunning Alps, where did you get the bulbs from??
 
As above if the old bulb works and the new one doesn't then it is a faulty bulb
 
Looks stunning Alps, where did you get the bulbs from??

ebay specials - not easy to install as the lower outer boot panel has to be removed.
 

Users who are viewing this thread

Back
Top Bottom