I did this job. It's literally a Generic 60mm Silicone T. You'll need an 80 to 100mm jubilee clip for the bottom that goes onto the intake. I would say whilst it works, it's a lot of hassle trying to heat up and slip the bottom end over the manifold. I imagine it'll be virtually impossible for some given the amount of boiling i had to do and i even had to debur some of the manifold to get it over. A better part would be a Step down from 70 to to 60mm with a 25mm branch but nobody does these. The 60mm end slides over the turbo perfectly. I didn't do this but thinking back now, if you want perfect alignment and to save the hassle out of measuring etc, slip the T over the turbo and shorten until the branch lines up with the hose from the PCV. I think that's the best way. Also bought my part off the shelf in Birmingham (creation autos) because I didn't want to wait and something was telling me this was just a generic T piece. Nearly half the price and no waiting but again, be warned the bottom clip they supplied wasn't big enough, you'll need an 80 to 100mm clip.
turbozentrum.co.uk
