Newbie.CLS
New Member
- Joined
- Mar 9, 2013
- Messages
- 1
- Car
- cls w218
Hello folks!
Firstly, my advance apologies if this issue on W218 has been discussed before.
My W218 was purchased in UK. I was offered a job relocation to Far East. Hence, decided to ship the car there first. So basically, car has not been in-use (due to shipment & port storage etc) for over 7 weeks or so. My shipping agent started the car (no jump start required) whilst still at the port when suddenly a warning appeared on speedometer “Stop vehicle. Vehicle too low”. Car suspension appears to be sagging, not lifting when started.
Diagnostic tool revealed “N51/3 airmatic control unit” error. Not sure why this occurs because my car has only done 5000 miles with no modifications since 2011. Any help from forum superstars here is much appreciated. Many thanks folks.
Firstly, my advance apologies if this issue on W218 has been discussed before.
My W218 was purchased in UK. I was offered a job relocation to Far East. Hence, decided to ship the car there first. So basically, car has not been in-use (due to shipment & port storage etc) for over 7 weeks or so. My shipping agent started the car (no jump start required) whilst still at the port when suddenly a warning appeared on speedometer “Stop vehicle. Vehicle too low”. Car suspension appears to be sagging, not lifting when started.
Diagnostic tool revealed “N51/3 airmatic control unit” error. Not sure why this occurs because my car has only done 5000 miles with no modifications since 2011. Any help from forum superstars here is much appreciated. Many thanks folks.
